Results 41 to 50 of about 2,686 (215)
Experimental Investigation on Wire Electric Erosion Behaviour of Silicon Dioxide Particulate Reinforced Composite [PDF]
Archives of Metallurgy and MaterialsThe intend of current study was focused on the prediction of material removal rate (MRR) and surface roughness (SR) for the AA7050-SiO2 composite during wire electric erosion or discharge machining (WEDM) process using a brass (Br) wire electrode.
S.V. Alagarsamy, B. Vinoth, D. Deepak
doaj +1 more source
Research on Micro Gear Design for WEDM
, 2011 WEDM (Wire Electrical Discharge Machining) is an effective method for machining micro gears. In this paper, aiming at WEDM characteristics, the gear design method is discussed. Based on gear meshing theory, the gear tooth profiles are generated.
Tie Li Ye, Ke Wei Hu, Lu Ling An
core +1 more source
Surface Integrity Study In WEDM Of Tungsten Carbide [PDF]
, 2008 This paper presented a study on the surface integrity of the machined surface of tungsten carbide (WC-15%Co) using wire electro-discharge machining (WEDM).
Mas Ayu, Hassan
core +2 more sources
Experimental Investigation of Wire EDM Process Parameters on Heat Affected Zone [PDF]
Engineering and Technology Journal, 2018 It is vital to study the impact of heat since it has an unwanted phenomenon on the operating life of parts produced, which is in turn effect the cost of production.
V.N. Najm
doaj +1 more source
EXPERIMENTAL EVALUATION OF WEDM MACHINED SURFACE WAVINESS
Acta Polytechnica, 2016 Wire Electrical Discharge Machining (WEDM) an unconventional machining technology which has become indispensable in many industries. The typical morphology of a surface machined using the electrical discharge technology is characterized with a large number of craters caused by electro-spark discharges produced during the machining process.
Mouralová, Kateřina +2 more
openaire +4 more sources
Journal of Manufacturing and Materials ProcessingGrinding wheel conditioning is critical for maintaining cutting efficiency and surface quality, yet conventional mechanical dressers struggle with metal-bonded superabrasive wheels.
Jan Wittenburg +7 more
doaj +1 more source
Research on the Tooth Surface Integrity of Non-Circular Gear WEDM Based on HPSO Optimization SVR
Applied Sciences, 2022 Non-circular gears have the characteristics of gear ratio accuracy, good dynamic performance, and wide application prospects but are difficult to manufacture.
Jiali Zhao +5 more
doaj +1 more source
Research on the ultrasonic assisted WEDM of Ti-6Al-4V
, 2013 An investigation was made for application of ultrasonic vibration in electro discharge machining (EDM) and wire EDM, and only the vibration of wire was found to have been applied on WEDM.
Soo, S.L. +4 more
core +1 more source
Applied Sciences, 2021 This paper proposes a wire electrical discharge machining (WEDM) product quality prediction method, called MTF-CLSTM, to integrate the Markov transition field (MTF) and the convolutional long short-term memory (CLSTM) neural network.
Jehn-Ruey Jiang, Cheng-Tai Yen
doaj +1 more source
Evaluation of performance WEDM by parameter design.
Journal of The Japan Society of Electrical Machining Engineers, 1989 The optimum machining conditions of a WEDM are estimated by the parameter design on the basis of Taguchi's method, and the performance evaluation is carried out.When a dimension is adopted as a characteristic, it is estimated that, by optimizing the average machining voltage and wire speed, the improvement of the accuracy is expected by about 50%, and ...
MATSUDA, Jiro +3 more
openaire +2 more sources