Results 201 to 210 of about 138,439 (275)

Composites of Shellac and Silver Nanowires as Flexible, Biobased, and Corrosion‐Resistant Transparent Conductive Electrodes

open access: yesAdvanced Functional Materials, EarlyView.
Shellac, a centuries‐old natural resin, is reimagined as a green material for flexible electronics. When combined with silver nanowires, shellac films deliver transparency, conductivity, and stability against humidity. These results position shellac as a sustainable alternative to synthetic polymers for transparent conductors in next‐generation ...
Rahaf Nafez Hussein   +4 more
wiley   +1 more source

Enhanced Switching Performance in Single‐Crystalline PbTiO3 Ferroelectric Memristors for Replicating Synaptic Plasticity

open access: yesAdvanced Functional Materials, EarlyView.
This study demonstrated single‐crystalline PbTiO3‐based memristors with atomically sharp interfaces, well‐ordered lattices, and minimal lattice mismatch. The devices exhibited an ON/OFF ratio exceeding 105, high stability, and rich resistance‐state modulation.
Haining Li   +7 more
wiley   +1 more source

Improving surgical phase recognition using self-supervised deep learning. [PDF]

open access: yesSci Rep
Centeno López A   +4 more
europepmc   +1 more source

Removal of Steroid Hormone Micropollutants by an Electrochemical Carbon Nanotube Membrane Flow‐Through Reactor: Role of Concentration and Degradation Mechanisms

open access: yesAdvanced Functional Materials, EarlyView.
A flow‐through electrochemical membrane reactor equipped with a carbon nanotube membrane eliminates the mass transfer limitation, achieving removals >97.5% for steroid hormone (SH) micropollutants through electrochemical adsorption and degradation, over a broad initial concentration varying from 50 to 106 ng L−1.
Siqi Liu   +2 more
wiley   +1 more source

Fast‐Responding O2 Gas Sensor Based on Luminescent Europium Metal‐Organic Frameworks (MOF‐76)

open access: yesAdvanced Functional Materials, EarlyView.
Luminescent MOF‐76 materials based on Eu(III) and mixed Eu(III)/Y(III) show rapid and reversible changes in emission intensity in response to O2 with very short response times. The effect is based on triplet quenching of the linker ligands that act as photosensitizers. Average emission lifetimes of a few milliseconds turn out to be mostly unaffected by
Zhenyu Zhao   +5 more
wiley   +1 more source

Boosting the Energy Density of “Anode‐Free” Lithium Metal Batteries via Electrospun Polymeric Scaffolds

open access: yesAdvanced Functional Materials, EarlyView.
While host structures are known to enhance the reversibility and safety of lithium metal deposition, their additional volume and weight often decrease the battery's energy density and specific energy. By combining a lightweight and porous scaffold of electrospun polymer with a thinner separator, this article demonstrates a simultaneous improvement of ...
Lennart Wichmann   +6 more
wiley   +1 more source

Home - About - Disclaimer - Privacy