Results 221 to 230 of about 47,683 (307)

Research on the Influence Mechanism of Thermal Load on the Au-Sn Sealing Weld State on Three-Dimensional DPC Substrates. [PDF]

Materials (Basel)
Zhao H, Cao L, Wang S, Zhang H, Chen M.
europepmc   +1 more source

Behavior of a Novel Cyclic Olefin‐Based Hot‐Melt Adhesive in CFRP Adhesive Joints Compared to Conventional Epoxy‐Based Structural Adhesives

Polymer Composites, EarlyView.
Rate‐dependent performance of composite adhesive joints using thermoset and thermoplastic adhesives, in terms of toughness and fatigue behaviour. ABSTRACT A recently developed hot‐melt adhesive (HMA) based on cyclic olefin chemistry, supplied as a transparent, non‐tacky thermoplastic film with a distinctive polymer microstructure, was evaluated in this
Hossein Malekinejad, Ricardo J. C. Carbas, Eduardo A. S. Marques, Lucas F. M. da Silva   +3 more
wiley   +1 more source

Comparative evaluation of Nb, Nb-Cu, and Ta-Cu interlayers on microstructural and mechanical behavior of dissimilar welds of grade 6 Ti and stainless steel. [PDF]

Sci Rep
Jawad M, Hanif MW, Ali MA, Jahanzaib M, Adediran AA, Jen TC.   +5 more
europepmc   +1 more source

Characteristics, properties and limitations of per‐ or polyfluoroalkyl substances (PFASs) and fluoropolymers

Polymer International, EarlyView.
An overview and categorization of man‐made per‐ or polyfluoroalkyl substances (PFASs) including low‐molar‐mass and high‐molar‐mass fluorochemicals, and their international regulations is presented. Though certain PFASs are toxic, bioaccumulative and cross the human cellular membranes, others, such as fluoropolymers, are safe, reliable and involved in ...
Bruno Améduri
wiley   +1 more source

Evaluation of signal disturbance and recovery in phased array ultrasonic inspection during welding. [PDF]

Weld World
Dimakos A, Sweeney NE, Loukas C, Thompson CD, Serjeant S, MacLeod CN, Mohseni E, Lines D, Sibson J.   +8 more
europepmc   +1 more source

Tuning the Morphology of Self‐Assembled Nanopatterns on MgO(001) Surfaces by Sequential Broad‐Beam Ion Irradiation

physica status solidi (RRL) – Rapid Research Letters, EarlyView.
A two‐step approach based on broad‐beam ion irradiation is demonstrated to produce fine‐tuned self‐assembled surface patterns on MgO(001). It shows an efficient route to modifying the crystalline MgO(001) surface topography in a controlled way, making use of its very specific behavior in terms of both the pattern morphology and patterning dynamics.
Denise J. Erb, Stefan Facsko
wiley   +1 more source

Actuation Strategies for Underwater Jet‐Propelled Soft Robots

Journal of Field Robotics, EarlyView.
ABSTRACT This review article examines jet‐propulsion mechanisms in underwater soft robotic systems, focusing exclusively on physically fabricated and experimentally validated robots. Covering research published from 2013 to 2025, this study classifies and evaluates jet‐propulsion robots based on their actuation mechanisms.
Angel Kitone, Mohammed Anteet, Pawandeep S. Matharu, Yara Almubarak   +3 more
wiley   +1 more source

Prediction of Mechanical Properties of Injection-Molded Weld Lines of Glass Fiber-Reinforced Composites. [PDF]

Polymers (Basel)
Bao Z, Yan Y, Zhang Y, Dong R, Han W, Liu Q.   +5 more
europepmc   +1 more source