Results 131 to 140 of about 18,277 (307)
Dynamic Range Compression of Thermograms for Assessment of Welded Joint Face Quality. [PDF]
Sensors (Basel), 2023 Jamrozik W, Górka J, Batalha GF.
europepmc +1 more source
Influence of Higher Tramp Element Level on the Weldability of Automotive Steels
steel research international, EarlyView.The use of green recycled steels is constantly expanding in the automotive industry. The increase in tramp elements resulting from the recycling of steel is problematic. Tramp elements can lead to a negative influence on the weldability. To understand the influence, the welding properties of three green steels are characterized. The potential limits of
Elias Gebhard Vogt +6 more
wiley +1 more source
Frontier Materials & TechnologiesOne of the important parameters influencing the formation of a weld during friction stir welding is the tool geometry, which affects the processes of heat generation and stirring of metals in their connection zone. These processes influence the formation
Igor N. Zybin, Darya A. Buzyreva
doaj +1 more source
Experimental and Numerical Analysis of Fracture Mechanics Behavior of Heterogeneous Zones in S690QL1 Grade High Strength Steel (HSS) Welded Joint. [PDF]
Materials (Basel), 2023 Tomerlin D +3 more
europepmc +1 more source
steel research international, EarlyView.Laser powder bed fusion of JIS SKD61 tool steel is systematically optimized using a Taguchi design and ANOVA. Hatch spacing and layer thickness are identified as dominant parameters controlling surface roughness and tensile strength. Subsequent tempering at 600°C improves microstructural stability and mechanical performance, enabling high‐density SKD61
Masrurotin Masrurotin +4 more
wiley +1 more source
Journal of Materials Research and TechnologyRevealing the plasticity-evolved behaviors is of great significance for developing high-reliability thick Ti–6Al–4V welded joint for deep-sea exploration equipment.
Junfeng Liu +6 more
doaj +1 more source
Mechanism Study of Stress Corrosion Behavior under Tensile and Compressive Stresses for Welded Joint Used in Nuclear Turbine Rotor. [PDF]
Scanning, 2023 Chu T.
europepmc +1 more source
Study of Typical Welded Joint Hot Spot Stress Concentration Factor
, 2010 Hot spot stress (HSS) approach is more applicable for fatigue evaluation, because it is more closer to the real stress at the welded notch than nominal stress.This paper studies a typical welded joint, fillet welded joint, which is used widely in high ...
Zhi Ming Liu, Bin Jie Wang, Qiang Li
core +1 more source
steel research international, EarlyView.Prebending of 304L/Q345R cladded plates significantly alters the subsequent weld thermal cycle and modifies the local interfacial microstructure. Combined electron backscatter diffraction (EBSD) and microscopy analysis demonstrates that deformation twinning, martensitic transformation, and defect initiation are concentrated at the trimaterial junction,
Ali Fahem +2 more
wiley +1 more source