Results 101 to 110 of about 6,616 (265)
steel research international, EarlyView.Paint baking of resistance spot welded joints of 2.0 GPa warm‐stamped medium‐Mn steel activates low‐temperature tempering, forming fine cementite in the fusion zone and enhancing toughness. Crack propagation resistance increases, shifting the failure mode from partial interfacial to complete pullout, with peak load and energy absorption rising ...
Sunusi Marwana Manladan +8 more
wiley +1 more source
steel research international, EarlyView.The high‐strain‐rate behavior of resistance spot‐welded DP800–DP1000 joints is investigated. Results show that microstructural gradients across BM–HAZ–FZ govern hardness, strain rate sensitivity, and failure modes. While strength increases with strain rate, energy absorption is controlled by ductility, with DP800–DP800 joints showing superior ...
Pankaj Shrivastava, Velaphi Msomi
wiley +1 more source
Damage Investigation of the Preform Operations for the Production of Rings for Ring Rolling
steel research international, EarlyView.Void evolution during the preforming operations of two industrial ring rolling process routes is investigated by combining metallographic characterization with a two‐scale finite element simulation approach. The results reveal that, despite differing initial void conditions, the preforming operations can be designed to effectively influence void ...
Laurenz Kluge +6 more
wiley +1 more source
Effect of Mn Content on Microstructure and Properties of Inconel718 Plate Welded Joint
TeshugangThe service performance of welded parts is directly impacted by the microstructure of the Inconel718 welded joint； however， there is a lack of comprehensive research on the impact of the Mn element on the microstructure and performance of the welded ...
Yang Yaqian +5 more
doaj
Structural Concrete, EarlyView.Abstract Precast reinforced concrete segmental linings are frequently used in modern tunneling. In these linings, the longitudinal joints typically have a reduced contact cross‐section and thus often govern the design, particularly in tunnels under high hydrostatic pressure or crossing squeezing or swelling ground with correspondingly high ...
Fabian Morger +2 more
wiley +1 more source
Structural Concrete, EarlyView.Abstract With the market introduction of new reinforcing materials, such as corrosion‐resistant steel, the effect of their stress–strain relationship on the ductility of reinforced concrete structures needs to be evaluated. Their moment‐curvature behavior significantly influences bending moment redistributions, rotation capacity, and deformation at ...
Nathalie Reckinger +2 more
wiley +1 more source
Fatigue life estimation in welded joints under multiaxial loadings
Fracture and Structural Integrity, 2009 Welded joints are frequently locations for cracks initiation and propagation that may cause fatigue failure of engineering structures. Biaxial or triaxial stress-strain states are present in the vicinity of welded joints, due to local geometrical ...
Andrea Carpinteri +2 more
doaj
Structural Concrete, EarlyView.Abstract The structural role of precast concrete walls with openings is often overlooked in design practice due to concerns about reduced stiffness, stress concentration, cracking around openings, and potential unexpected failure modes under seismic loading.
Gonçalo Marreneca +2 more
wiley +1 more source
Structural Concrete, EarlyView.Abstract In this study, the structural behavior of small square steel tube‐reinforced self‐compacting concrete (SSTR‐SCC) columns is investigated under symmetric and asymmetric biaxial eccentric loads. Twelve specimens were cast and tested under biaxial eccentric loads.
Muhammad Naveed +2 more
wiley +1 more source
A Dataset of Fatigue Properties for Welded Joints. [PDF]
Sci DataDeng C +6 more
europepmc +1 more source