Results 31 to 40 of about 1,336 (210)

Autonomous Folding of Soft Matter From Living Polymers

open access: yesAdvanced Materials, EarlyView.
Origami structures are endowed with “living” polymer creases that grow, remodel, and stiffen in response to nutrient solutions. This post‐fabrication growth enables autonomous folding, iterative regrowth, and mechanical tuning involving origami assemblies, such as cranes, Miura‐ori tessellations, rigid and non‐rigid square‐twist patterns, establishing ...
Jiahe Huang   +6 more
wiley   +1 more source

Sustainable Poly(Lactic Acid)/Graphene Oxide Bioelectronic Platform for Neurotransmitters Sensing and Tunable Stimulation of Astrocytes

open access: yesAdvanced Materials, EarlyView.
This work introduces sustainable PLA/graphene oxide bioelectronic interfaces featuring electrodes with tunable conductivity and strong electrocatalytic performance. These platforms were used to implement a new method for tuning astrocyte Ca2+ signaling and for the efficient detection of key biomarkers.
Alessandra Scidà   +15 more
wiley   +1 more source

Elastomeric 3D‐Printed Microenvironments Enable Nanonewton Force Measurements in Healthy and Diseased Human Pluripotent Stem Cell‐Derived Neuroepithelial Cells

open access: yesAdvanced Materials, EarlyView.
We present elastomeric three‐dimensional (3D) microstructures fabricated via two‐photon polymerization (2PP) and post‐processed through wet etching, for quantifying nanonewton (nN)‐scale forces applied by healthy and diseased neural cells. The mechanically characterized free‐standing beam architectures enable measurement of traction forces of ...
Pieter F. J. van Altena   +7 more
wiley   +1 more source

Spatial‐Compatibility‐Assisted Molecular Intercalation in MXenes

open access: yesAdvanced Materials, EarlyView.
This work demonstrates a solvent–free NH4F–mediated route for simultaneous Al removal and molecular intercalation in MXenes. Intercalants are selected by comparing their crystallographic X, Y, and Z dimensions with the MXene interlayer spacing, establishing a spatial‐compatibility criterion that rationalizes guest–host matching and enables predictive ...
Minhao Sheng   +6 more
wiley   +1 more source

Toward Pore‐Engineered 3D‐Printed Materials for Sorption Water Harvesting, Interfacial Evaporation, and Radiative Cooling

open access: yesAdvanced Materials, EarlyView.
Water harvesting, radiative cooling, and interfacial solar evaporation are fundamentally governed by coupled heat, mass, and light transport processes. These processes are mediated by pore architecture, including pore size, connectivity, and hierarchical organization.
Dejan J. Trajkovski   +5 more
wiley   +1 more source

The influence of the exterior temperature on natural venting systems in large atria [PDF]

open access: yes, 2008
RESUMEN. Entre las diferentes estrategias de Control y Evacuación de los Humos del Incendio, los sistemas de ventilación natural presentan numerosas ventajas frente a la ventilación mecánica – fundamentalmente una menor inversión tanto en equipos ...
Capote Abreu, Jorge Arturo   +9 more
core   +1 more source

Fabrication of Aligned Polycaprolactone Nanofibrillar Bundles to Control Cell‐Mediated Collagen Deposition in Engineered Cartilage

open access: yesAdvanced Materials, EarlyView.
Melt electrofibrillation (MEF) enables the fabrication of nanofibrillar PCL scaffolds with defined architectures that guide cellular alignment and retention during cartilage tissue engineering. Unlike conventional melt electrowriting, MEF consistently directs collagen type II‐rich extracellular matrix organization, providing a tunable platform to ...
Alba Pueyo Moliner   +10 more
wiley   +1 more source

Flexible Pressure Sensor With Co‐Optimized Sensitivity and Linearity Based on Gradient Toroidal Microstructures

open access: yesAdvanced Materials Technologies, EarlyView.
A flexible piezoresistive pressure sensor with gradient toroidal CNT/PDMS microstructures is reported. The hierarchical geometry enables sequential electrode contact, achieving a sensitivity of 256.20 kPa−1 and linear response (R2 = 0.99) over 0–1000 kPa.
Rongmei Wang   +8 more
wiley   +1 more source

Freeform Light Routing in Nearly‐Hyperuniform Slabs: Toward a General‐Purpose Design Platform for Integrated Photonics

open access: yesAdvanced Optical Materials, EarlyView.
Nearly hyperuniform disordered photonic slabs guide light along prescribed freeform pathways without relying on lattice symmetry. A pathway‐first design embeds curved channels within a photonic bandgap hyperuniform network, maintaining high transmission through freeform bends.
Timothy Amoah   +8 more
wiley   +1 more source

Sustainable Fabrication of Tailored Bone Substitutes: From High‐Throughput Scaffold Manufacturing, Scaled‐Up HMSC Expansion to Dynamic Cultivation in a Perfusion Bioreactor

open access: yesAdvanced Science, EarlyView.
ABSTRACT The demand for off‐the‐shelf biocompatible bone substitutes has driven the development of numerous independent in vitro technologies to generate products resembling physiological tissues. Due to technical challenges and overly simplified cultivation approaches/niches, the end‐products are often uniformly shaped and inferior to native bone ...
Franziska Braun   +10 more
wiley   +1 more source

Home - About - Disclaimer - Privacy