Results 161 to 170 of about 6,568,643 (305)

Expression of Concern: The costs of wind energy permitting compliance actions for regulated bats in the US. [PDF]

PLoS One
PLOS One Editors.
europepmc   +1 more source

Microstructure‑Dependent Phase Transformations Under High‑Pressure Laser Heating in Additively Manufactured AlCrFe2Ni2

Advanced Engineering Materials, EarlyView.
Additively manufactured AlCrFe2Ni2 with contrasting BCC/B2‐dominant and lamellar FCC + BCC/B2 microstructures exhibits the same pressure‐induced BCC/B2 → HCP transformation. Under laser heating at high pressure, HCP is destabilized, and a cubic BCC/B2 + FCC assemblage is recovered, while the lower‐scan‐speed microstructure transforms at a lower ...
Raimundas Sereika, Hunter Kantelis, Yogesh K. Vohra, Shengbiao Zhang, Wuxian Yang, Wen Chen   +5 more
wiley   +1 more source

Aeroelastic modelling and comparison of advanced active flap control concepts for load reduction on the Upwind 5MW wind turbine

, 2009
A newly developed comprehensive aeroelastic model is used to investigate active flap concepts on the Upwind 5MW reference wind turbine. The model is specially designed to facilitate distributed control concepts and advanced controller design.
Barlas, A. (author), van Kuik, G.A.M. (author)   +1 more
core  

Power quality enhancement in wind energy applications through E2PLL-based DSTATCOM control. [PDF]

PLoS One
Özer AS, Sevilmiş F, Karaca H, Ahmed H.   +3 more
europepmc   +1 more source

Impact of Hydrogen Incorporation on Electronic and Magnetic Structure of X2CrNi18‐9 Stainless Steel

Advanced Engineering Materials, EarlyView.
Hydrogen uptake in austenitic stainless steel alters both its electronic and magnetic structure. Seebeck measurements reveal hydrogen‐induced shifts in the electronic density of states, while neutron scattering uncovers nanoscale inhomogeneities that grow upon hydrogen incorporation, with the most pronounced effect observed in the PBF as‐built state ...
Torben Tappe, Louis Becker, Gaurav Kanu, Thomas F. Headen, Dirk Honecker, Gabi Schierning, Santiago Benito, Sebastian Weber, Klara Lünser, Sabrina Disch   +9 more
wiley   +1 more source

Wind Power Development: Opportunities and Challenges [PDF]

In this study, the prospects of wind power at the global level are reviewed. Existing studies indicate that the earth’s wind energy supply potential significantly exceeds global energy demand.
Govinda R. Timilsina, G. Cornelis van Kooten   +1 more
core  

Breaking the Betz limit: High-altitude wind energy toward future decarbonization. [PDF]

Innovation (Camb)
Wang W, Wang J, Zou Y, Jiang Y, Liu D, Song J, Lu C.   +6 more
europepmc   +1 more source

Thermal Cycle–Microstructure–Property Relationships in Rail Steel Heat‐Affected Zone Simulated by Gleeble

Advanced Engineering Materials, EarlyView.
Microstructural evolution of premium rail steel during flash butt welding (FBW), comparing physically simulated heat‐affected zones with actual weld regions. Thermal cycles induce phase transformations and microstructural heterogeneity that influence weld quality and mechanical performance. These findings provide insights into optimizing FBW parameters
Emmanoelle Cintra da Cunha Araújo, João Marcos da Silva Nunes, Marcelly Cristiny Nunes de Carvalho, Alex Rojas, Cristie Luis Kugelmeier, Cristhian Ricardo Loayza Loayza, João Carlos Ferreira, Maria Veronica Goncalves Rodrigues, Rute Sayuri Kano, Isaac Araújo Furtado, Jacyara Dalylla da Silva Nunes, Jhonatan Peres de Sousa, Marcos Natan da Silva Lima, Eden Santos Silva, Gedeon Silva Reis, Samuel Filgueiras Rodrigues   +15 more
wiley   +1 more source

A novel implementation of wind energy in buildings based on synthetic jet concept

, 2015
The flow around the baseline building is compared to the flow pattern obtained by introducing an air duct on the top of it, which is blowing a fixed air mass flow rate (the jet).
Bedon G., De Carli M., Benini E., De Betta S., Elarga H.   +4 more
core  

Climate change impact on future Egypt's wind energy: a CMIP6-based assessment of power output. [PDF]

Sci Rep
Hamed MM, Sobh MT, El-Mallawany AR, Elgharib AO.   +3 more
europepmc   +1 more source