Results 141 to 150 of about 577 (177)
Some of the next articles are maybe not open access.
MPPT controlled wind energy conversion system(WECS) supplying DC micro-grid
2020 Third International Conference on Smart Systems and Inventive Technology (ICSSIT), 2020Due to popularity and support, especially for wind, the use of renewable energy is increasing. This also enables the generation of electricity without the emission of polluting gasses. Renewable energy resources are used as substitute for fossil fuels in electrical power generation.
M P Shadakshara Swamy +4 more
openaire +1 more source
Sensorless control for wind energy conversion system (WECS) with power quality improvement
2014 IEEE PES General Meeting | Conference & Exposition, 2014This paper presents a sensorless control of dc bus voltage of inverter and speed and rotor position of permanent magnet synchronous generator (PMSG) using the extended Kalman filter (EKF) for wind application. The analysis and modeling of a variable speed wind turbine (VSWT) based on PMSG connected to the grid are developed.
Mounir Benadja, Ambrish Chandra
openaire +1 more source
Condition Monitoring, and Fault Detection and Diagnostics of Wind Energy Conversion System (WECS)
2020Wind energy has a major contribution to the catalog of renewable energy generation and also the most efficient energy solutions driver. As the requirement and utilization for wind energy persist to develop exponentially, reduction in cost of O&M and reliability growth are the prime concerns in the maintenance strategies of wind energy conversion system
Tarkeshwar Mahto +2 more
openaire +1 more source
Keynote speech 2: Wind energy conversion systems (WECS)
2013 1st International Conference & Exhibition on the Applications of Information Technology to Renewable Energy Processes and Systems, 2013Constantly growing demand for energy cannot continue indefinitely relies only upon fossil fuel. The earth's finite supply will eventually exhaust. Energy is a major key to industrial development and the world's well-being. The awareness of depletion of fossil fuel resources has challenged scientists and engineers to search for alternative energy ...
openaire +1 more source
Soft Computing, 2020
This paper proposes a hybrid algorithm-based control model for enhancing the low voltage ride through (LVRT) capability of the doubly fed induction generator (DFIG) system. The hybrid algorithm is the combined execution of both modified elephant herding algorithm (MEHA) and random forest (RF) algorithm, and hence the technique is named as MEHRFA.
Gangikunta Manohar +2 more
openaire +1 more source
This paper proposes a hybrid algorithm-based control model for enhancing the low voltage ride through (LVRT) capability of the doubly fed induction generator (DFIG) system. The hybrid algorithm is the combined execution of both modified elephant herding algorithm (MEHA) and random forest (RF) algorithm, and hence the technique is named as MEHRFA.
Gangikunta Manohar +2 more
openaire +1 more source
Energy, 2014
Abstract This paper presents a complete design of a two-level control system to capture maximum power in wind energy conversion systems. The upper level of the proposed control system adopts a modified line search optimization algorithm to determine a setpoint for the wind turbine speed.
M. Elnaggar +2 more
openaire +1 more source
Abstract This paper presents a complete design of a two-level control system to capture maximum power in wind energy conversion systems. The upper level of the proposed control system adopts a modified line search optimization algorithm to determine a setpoint for the wind turbine speed.
M. Elnaggar +2 more
openaire +1 more source
Overview of Wind Energy Conversion Systems (WECS)
2019The aim of this chapter is to present an overview of the state of technology and discuss some technology tendency in the Power Electronics (PE) used for Wind Power Applications (WPA). Firstly, technological and commercial developments in wind power generation are generally discussed.
openaire +1 more source
2014 Electrical Power, Electronics, Communicatons, Control and Informatics Seminar (EECCIS), 2014
The purpose of the implementation of this study were: (a) Determine the amount of air flow rate of air flow out of the exhaust pipe, (b) Identify the influence of wind speed in the free air against air flow out from the exhaust pipe, (c) Determine the amount of electrical power and energy potential that can be generated, and (d) Identify the ...
Unggul Wibawa, Teguh Utomo
openaire +1 more source
The purpose of the implementation of this study were: (a) Determine the amount of air flow rate of air flow out of the exhaust pipe, (b) Identify the influence of wind speed in the free air against air flow out from the exhaust pipe, (c) Determine the amount of electrical power and energy potential that can be generated, and (d) Identify the ...
Unggul Wibawa, Teguh Utomo
openaire +1 more source
2019 IEEE 11th International Conference on Humanoid, Nanotechnology, Information Technology, Communication and Control, Environment, and Management ( HNICEM ), 2019
A wind turbine is a device that converts kinetic energy from the wind into electrical energy. The main purpose of this study is to design, construct and test a wind turbine with fuzzy logic controller to manipulate the pitch angle of the blades of the wind turbine. The fuzzy logic controller serves as the main control for the pitch angle control of the
J. V. Demata +5 more
openaire +1 more source
A wind turbine is a device that converts kinetic energy from the wind into electrical energy. The main purpose of this study is to design, construct and test a wind turbine with fuzzy logic controller to manipulate the pitch angle of the blades of the wind turbine. The fuzzy logic controller serves as the main control for the pitch angle control of the
J. V. Demata +5 more
openaire +1 more source
Energy, 2010
Abstarct The present paper aims at modeling and simulating a WTIG (wind turbine and an induction generator) system as an electricity source in the southern parts of Algeria. System simulation has been done using a program developed employing the MATLAB-SIMULINK software package.
Djohra Saheb-Koussa +4 more
openaire +1 more source
Abstarct The present paper aims at modeling and simulating a WTIG (wind turbine and an induction generator) system as an electricity source in the southern parts of Algeria. System simulation has been done using a program developed employing the MATLAB-SIMULINK software package.
Djohra Saheb-Koussa +4 more
openaire +1 more source