Results 11 to 20 of about 1,620 (220)
Fault Tolerant Control of DFIG-Based Wind Energy Conversion System Using Augmented Observer
An augmented sliding mode observer is proposed to solve the actuator fault of an uncertain wind energy conversion system (WECS), which can estimate the system state and reconstruct the actuator faults.
Xu Wang, Yanxia Shen
doaj +2 more sources
This paper presents a technical overview for Switched Reluctance Generators (SRG) in Wind Energy Conversion System (WECS) applications. Several topics are discussed, such as the main structures and topologies for SRG converters in WECS, and the ...
Zeineb Touati +3 more
doaj +2 more sources
The parallel system is a kind of scientific research method based on an artificial system and computational experiments, which can not only reflect the dynamic process of the real system but also optimize its control process in real time. Given the rapid
Zhicheng Lin +4 more
doaj +2 more sources
Performance Analysis of Stand-Alone Wind Energy Power Conversion System [PDF]
Earlier, the production of electricity was primarily reliant on non-renewable sources such as coal and diesel. However, these sources have limited availability and will eventually be depleted. Therefore, it is crucial to shift our focus towards renewable
Singar Mahendra Kumar +3 more
doaj +2 more sources
A Pull-Out Mooring Wave Energy Converter: Design, Analysis, and Application. [PDF]
A pull‐out mooring wave energy converter (POM‐WEC) with a high‐performance electromagnetic power take‐off system efficiently converts low‐frequency wave excitation into high‐speed rotor motion, enabling reliable energy harvesting in real marine environments.
Xu W, Chen J, Gu S, Feng X, Wang F.
europepmc +2 more sources
Generic maximum power point tracking controller for small-scale wind turbines [PDF]
The output power of a wind energy conversion system (WECS) is maximized if the wind rotor is driven at an optimal rotational speed for a particular wind speed. To achieve this, a Maximum Power Point Tracking (MPPT) controller is usually used.
Jovanovic, Milutin +4 more
core +1 more source
Recently, controlling a wind energy conversion system (WECS) under fluctuating wind speed and enhancing the quality of power delivered to the grid has been a demanding challenge for many researchers.
Amir Raouf +4 more
doaj +1 more source
The Energy Processing by Power Electronics and its Impact on Power Quality [PDF]
This paper discusses the electrical architectures adopted in wind turbines and its impact on the harmonic flux at the connected electric network. The integration of wind electric generators with the power grid needs energy processing by power electronics.
J.E. Rocha +3 more
core +1 more source
Wind Energy Conversion System (WECS) plays an inevitable role across the world. WECS consist of many components and equipment’s such as turbines, hub assembly, yaw mechanism, electrical machines; power electronics based power conditioning units ...
K. Padmanathan +9 more
doaj +1 more source
Three-phase AC-DC Converter for Direct-drive PMSG-based Wind Energy Conversion System
In this paper, a wind energy conversion system (WECS) is presented for the electrification of rural areas with wind energy availability. A three-phase AC-DC converter based on a bridgeless Cuk converter is used for power extraction from the permanent ...
Kumar Abhishek Singh +2 more
doaj +1 more source

