Results 141 to 150 of about 85,424 (309)
Hierarchical multi‐material TPMS lattices are engineered as flexible tactile sensors by combining soft and stiff elastomeric layers with a conformal conductive coating. The bilayer architecture delivers sensitivity at low pressures while maintaining a broad detectable range under large loads, enabling reliable pressure and vibration monitoring for ...
Reza Noroozi +3 more
wiley +1 more source
Schottky Barrier Engineering in n‐Type Organic Source‐Gated Transistors Enabling High Conductance
This study introduces a modified source electrode architecture for n‐type organic source‐gated transistors (OSGTs). By integrating Schottky and Ohmic contact regions, the design achieves a thinner depletion envelope, enhancing mobility nearly tenfold and reducing threshold voltage.
Yonghee Kim +4 more
wiley +1 more source
Reconnaissance Peptide Labeling Grain Boundary of Chemically Grown MoS2 Polycrystalline Monolayer
Self‐assembled peptides on substrates, through adsorption and aggregation, offer an alternative way to label grain boundaries in chemically grown single‐layer polycrystalline MoS2. During an early nucleation step, peptides preferentially bind to grain boundaries.
Linhao Sun, Jinhua Hu
wiley +1 more source
Performance Analysis of NACA2420 as Wind Turbine Propeller Blade
Wind is one of the popular renewable energy sources which is abundantly available either in land or at sea. The wind energy can be converted into electrical energy using wind turbines or wind energy conversion systems.
Sulaeman Mustafa +3 more
doaj
Experimental and simulation Studies of a Two Seater Light Aircraft [PDF]
This paper presents the aerodynamic studies carried out on a three-dimensional aircraft model. The test model is a 15% scaled down from a two-seater light aircraft that close to the Malaysian made SME MD3-160 aircraft. The aircraft model is equipped with
Awang, Mohd. Zailani +5 more
core
A flexible piezoresistive pressure sensor with gradient toroidal CNT/PDMS microstructures is reported. The hierarchical geometry enables sequential electrode contact, achieving a sensitivity of 256.20 kPa−1 and linear response (R2 = 0.99) over 0–1000 kPa.
Rongmei Wang +8 more
wiley +1 more source
Experimental investigation of flow over a backward facing step-progress report [PDF]
The sizes and arrangement of the wind tunnel used for the experimentation are described. The specifications for the cold-wire anemometers, hot-wire anemometers, cold-wire rakes, and miniature 3-wire probe are proveded.
Browne, L. W. B.
core +1 more source
On the wake of a Darrieus turbine [PDF]
The theory and experimental measurements on the aerodynamic decay of a wake from high performance vertical axis wind turbine are discussed. In the initial experimental study, the wake downstream of a model Darrieus rotor, 28 cm diameter and a height of ...
Base, T. E. +3 more
core +1 more source
Nanocrystal Quality–Controlled Scintillation in Porous YAG:Ce Aerogels
High‐temperature thermal treatment of YAG:Ce nanoscintillator aerogels increases light yield under ionizing radiation by up to eightfold without affecting timing performance. Additionally, low‐temperature atmospheric treatments reversibly modify the cerium oxidation state, revealing strong defect sensitivity and offering new strategies to optimize ...
Pavlo Mai +11 more
wiley +1 more source
Collision‐Resilient Winged Drones Enabled by Tensegrity Structures
Based on structures of birds such as the woodpeck, this article presents the collision‐resilient aerial robot, SWIFT. SWIFT leverages tensegrity structures in the fuselage and wings which allow it to undergo large deformations in a crash, without sustaining damage. Experiments show that SWIFT can reduce impact forces by 70% over conventional structures.
Omar Aloui +5 more
wiley +1 more source

