Results 11 to 20 of about 3,358,020 (299)
Formulation and System Identification of the Equations of Motion for a Dynamic Wind Tunnel Facility. [PDF]
, 2008 This document describes the equations of motion of an aircraft model tested in Cranfield’s 4 degreeof- freedom (DoF) wind tunnel facility. In previous research, the equations have been derived assuming that the model’s centre of gravity (cg) is ...
Cooke, A. K., Carnduff, S. D.
core +7 more sources
A Wind Tunnel Simulation Facility for On-Road Transients [PDF]
, 2014 This paper outlines the creation of a facility for simulating on-road transients in a model scale, ¾ open jet, wind tunnel. Aerodynamic transients experienced on-road can be important in relation to a number of attributes including vehicle handling ...
Sims-Williams, D.B. +5 more
core +1 more source
Application of Advanced CFD Tools for High Reynolds Number Testing. [PDF]
, 2008 Numerical simulations of the DLR F11 high lift half model in landing configuration in the test section of the ETW wind tunnel have been carried out with the unstructured CFD code DLR TAU.
Wichmann, Georg +3 more
core +1 more source
Wind-tunnel pressure measurements on model-scale rigid downwind sails [PDF]
, 2013 This paper describes an experiment that was carried out in the Twisted Flow Wind Tunnel at The University of Auckland to measure a detailed set of pressure distributions on a rigid 1/15th scale model of a modern asymmetric spinnaker. It was observed that
VIOLA, Ignazio Maria +7 more
core +1 more source
Subsonic Wind Tunnels Air Speed Control Devices Base on Arduino Controller [PDF]
E3S Web of ConferencesThis study discusses the process of making an airspeed control device for wind tunnels using Arduino as the main component of the controller unit. Wind tunnel testing is carried out at varying airspeeds to obtain optimal results.
Setiawan M. Yasep +7 more
doaj +1 more source
A technique for reducing supersonic transient loads on internal wind tunnel balances [PDF]
TehnikaDesign of slender supersonic missiles requires a comprehensive experimental support in the form of wind tunnel data for a wide range of flight parameters (angle of attack and Mach number). However, in supersonic wind tunnel testing, the problem exists of
Vuković Đorđe S. +1 more
doaj +1 more source
majaczech/wind-tunnel: 3D Printed Wind Tunnel
, 2022 3D Printed Wind Tunnel This is 3D printed wind tunnel with Arduino-based unit. This source describes Open Hardware and is licensed under the CERN-OHL-S v2 Experience with Arduino platform is required and supervision from a qualified electric engineering
majaczech
core +1 more source
Advances in Bridge Engineering, 2023 Appropriate modeling of an experimental technology is necessary in order to estimate the aerodynamic characteristic of railway trains and infrastructure (e.g., bridges).
Simin Zou, Xuhui He
doaj +1 more source
Journal of Engineering, 2011 A low speed open circuit wind tunnel has been designed, manufactured and constructed at the Mechanical Engineering Department at Baghdad University - College of Engineering.
Ihsan Y. Hussain +3 more
doaj +1 more source
Wind tunnel test study on the wind load variation law of a point focus solar furnace
Frontiers in Energy Research, 2023 This work studied the wind load acting on a point focus solar furnace composed of a 110 m2 heliostat and a 77 m2 concentrator through wind tunnel testing.
Mingfei He +19 more
doaj +1 more source