Results 41 to 50 of about 3,581 (241)

Modeling Dislocation Cutting of γ′ Precipitates in Ni‐Base Superalloys: Linking Atomistic and Dislocation Dynamics Simulations

Advanced Engineering Materials, EarlyView.
Dislocation cutting of γ′ precipitates in Ni‐based superalloys is investigated by linking atomistic simulations with discrete dislocation dynamics. The critical cutting stress is shown to be governed by the antiphase boundary energy, while line tension effects promote edge‐preferred cutting.
Frédéric Houllé, Siwen Gao, Marc Fivel, Anxin Ma, Daria Smirnova, Sriram Anand, Arun Prakash, Julien Guénolé, Alexander Hartmaier, Erik Bitzek   +9 more
wiley   +1 more source

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

Advanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal, Cevher Kursat Macit, Merve Ayık, Hakan Tutumlu   +3 more
wiley   +1 more source

Wind Turbine Gearbox Early Fault Detection Using Mel‐Frequency Cepstral Coefficients of Vibration Data

Structural Control and Health Monitoring
A methodology utilizing vibration data and Mel‐frequency cepstral coefficients (MFCCs) for wind turbine condition monitoring is developed to detect incipient faults in the wind turbine gearbox. This approach provides a more efficient and cost‐effective solution compared to traditional condition monitoring techniques relying on physical inspections ...
Velandia Cardenas, Cristian, Vidal Seguí, Yolanda, Pozo Montero, Francesc   +2 more
openaire   +2 more sources

Elastic Properties and Thermal Expansion Behavior of a Polycrystalline VMnFeCoNi High‐Entropy Alloy

Advanced Engineering Materials, EarlyView.
The high‐entropy alloy (HEA) V20Mn20Fe20Co20Ni20 (composition in at.%) can be made single‐phase face‐centered cubic (FCC) when annealed above 1338 K followed by water quenching. In this state, the alloy exhibits the greatest strength‐ductility combination of any quinary single‐phase FCC HEA.
Guillaume Laplanche, Marie Münchhalfen, Aditya Srinivasan Tirunilai, Jürgen Schreuer   +3 more
wiley   +1 more source

Superlubricity and Corrosion Inhibition Properties of Solvate Ionic Liquids in Hybrid Carbon Fiber Reinforced Plastic–Steel Interfaces

Advanced Engineering Materials, EarlyView.
Solvate ionic liquids lubrication reduced the coefficient of friction by ∼60% compared to dry sliding, reaching steady‐state values as low as 0.04–0.05. Corrosion weight‐loss measurements in 1 M HCl further demonstrated significant inhibition behavior, with only 100 ppm of [Li(G3)][TFSI] (∼68.5 μL/L) reducing corrosion‐product weight loss by 63 ...
Sameh Dabees, Timothy Harte, Bhagya Dharmasiri, Y. Athulya Wickramasingha, David J. Hayne, Daniel J. Eyckens, Luke C. Henderson   +6 more
wiley   +1 more source

Experimental Study on Wind-Induced Vibration of Single-Axis Solar Tracker

Applied Sciences
To investigate the wind-induced vibration of a single-axis solar tracker, this study employs a combination of rigid model pressure measurement wind tunnel tests and finite element calculations.
Tie Chen, Hongtao Zhang, Xiaobin Zhang, Fei Wang, Yuxue Li, Qiaochu Zhao, Yihao Ge   +6 more
doaj   +1 more source

Robust Electrocaloric Performance Enabled by Highly‐Polar Frustrated Nanodomains in NaNbO3‐Based Ferrodistortive Relaxor

Advanced Functional Materials, EarlyView.
P4bm framework in NaNbO3‐Ba(Ti, Hf)O3 ferrodistortive relaxor entails short‐range and highly‐polar ferrodistortive orders. The abundant highly‐polar orders facilitate to increase entropy change, and robust octahedral oxygen tilt enables to impede thermal perturbations.
Feng Li, Changshun Dai, He Qi, Jiecheng Liu, Xiaoming Shi, Heng Zhou, Qiong Yang, Mingsheng Long, Lei Shan, Chunchang Wang, Jianli Wang, Zhenxiang Cheng   +11 more
wiley   +1 more source

Wind-Induced Response of an L-Shaped Cable Support Glass Curtain Wall

Shock and Vibration, 2017
Due to its flexibility, cable support glass curtain wall is sensitive to wind loads and its wind-induced dynamic response has attracted more and more attention recently.
Yan Yu, Tao Liu, Qilin Zhang, Bin Yang
doaj   +1 more source

Three‐Dimensional Anomalous Hall Sensing Enabled By Spin–Orbit Torque Driven Domain Reconfiguration In Chiral Multilayers

Advanced Functional Materials, EarlyView.
A three‐dimensional magnetic field sensor is realized in chiral W/CoFeB/MgO multilayers, where spin–orbit torques reversibly reconfigure homochiral stripe domains. The symmetry of the torque enables offset‐free in‐plane sensing, while the reproducible domain reconfiguration extends the linear out‐of‐plane range. An anomalous Hall readout delivers large‐
Sabri Koraltan, Rahul Gupta, Reshma Peremadathil Pradeep, Fabian Kammerbauer, Iryna Kononenko, Klemens Prügl, Michael Kirsch, Bernd Aichner, Santiago Helbig, Florian Bruckner, Claas Abert, Andrada Oana Mandru, Armin Satz, Gerhard Jakob, Hans Josef Hug, Mathias Kläui, Dieter Suess   +16 more
wiley   +1 more source

Influence of the blade size on the dynamic characteristic damage identification of wind turbine blades

Nonlinear Engineering, 2023
In this article, the sensitivity coefficients of dynamic characteristic damage identification of blades with different sizes were investigated. The results show that the first third-order vibration modes of the blade before and after damage are ...
Chen Peng, Chen Bei
doaj   +1 more source