Results 101 to 110 of about 532,635 (266)
Material‐Gradient Enabled Enhancement of Strength and Strain‐Hardening of Lattice Structures
Advanced Science, Volume 12, Issue 48, December 29, 2025.This study employs material gradients in lattice structures via alloy‐controlled additive manufacturing, decoupling mechanical behavior from geometry. Gradients guide stable plastic fronts, enhancing plateau stress and energy absorption by up to 25.4%.
Junhao Ding +5 more
wiley +1 more source
Trim cut machining and surface integrity analysis of Nimonic 80A alloy using wire cut EDM
Engineering Science and Technology, an International Journal, 2017 This present work deals with the features of trim cut wire EDM machining of Nimonic 80A in terms of machining parameters, to predict material removal rate (MRR), surface roughness (Ra), wire wear ratio (WWR) and microstructure analysis.
Amitesh Goswami, Jatinder Kumar
doaj +1 more source
Design and Fabrication of cross corrugated recuperator fins for a micro gas turbine [PDF]
, 2008 The National Aerospace Laboratories, Bangalore is involved in the development of a 10kW micro gas turbine (MGT). A recuperator is mandatory for an MGT to boost the thermal efficiency of the unit.
Ramamurthy, S, Thennavarajan, S
core +1 more source
Crack path selection at the interface of wrought and wire+arc additive manufactured Ti–6Al–4V [PDF]
, 2016 Crack propagation deviation tendency in specimens containing an interface between wrought alloy substrate and Wire + Arc Additive Manufacture (WAAM) built Ti–6Al–4V is investigated from the viewpoints of microstructure, residual stress and bi-material ...
Addison +39 more
core +3 more sources
Design and Fabrication of a Self‐Driven Air Purifying Bicycle With Real‐Time Monitoring System
Engineering Reports, Volume 7, Issue 12, December 2025.This study presents a self‐powered air purifying bicycle that delivers real‐time filtered airflow based on environmental and physiological feedback, significantly reducing cyclist exposure to PM2.5 and VOCs while enhancing urban air quality through dual‐channel purification.
Manpreet Singh +3 more
wiley +1 more source
Wire EDM Process of AISI 431 Martensitic Stainless Steel: A Machinability Investigation
Engineering ProceedingsThe wire EDM process for AISI 431 martensitic stainless steel involves meticulously investigating its machinability. This study explores the intricate details of the machining process, considering factors such as material characteristics and cutting ...
Balasubramaniyan Chandrasekaran +4 more
doaj +1 more source
Defence Technology, 2019 WEDM is used in machining conductive materials where it is required to obtained complicated and intricate shapes with high accuracy. Various applications are in the field of automobile, medical industries, aerospace etc.
Tina Chaudhary +2 more
doaj +1 more source
Embedding of fibre optic sensors within flexible host [PDF]
, 2009 This work deals with the establishment of a UV polymerisation procedure combined with moulding technology towards the development of a mass production technology for the fabrication of flexible polymers with optical fibres embedded.
Dubruel, Peter +7 more
core
Engineering ReportsCO2 laser cutting and electrical discharge machining (EDM) wire cutting are two advanced thermal energy‐based methods widely utilized for precision profile cutting tasks.
A. Parthiban +7 more
doaj +1 more source
Effect of surface finishing on tribological properties of ZrO2-based composites [PDF]
, 2010 Laboratory-made ZrO2-based composites with 40 vol. % WC, TiCN or TiN were tested in dry sliding contact with WC-6wt%Co cemented carbide using an ASTM G133 pin-on-flat configuration.
Bonny, Koenraad +5 more
core