Properties Evaluation of Thin Microhardened Surface Layer of Tool Steel after Wire EDM
Metals, 2016 This paper describes results of experimental research on the thin microhardened surface layer of a machined surface that occurs in materials using wire electrical discharge machining (WEDM) with brass wire electrode. The direct influence of microhardened
Ľuboslav Straka +2 more
doaj +1 more source
Comparison of the shaping characteristics of Neolix and Protaper Universal systems in preparation of severely-curved simulated canals [PDF]
, 2017 The aim of this in vitro study was to compare the shaping characteristics of two types of nickel-titanium endodontic file systems with regard to the following parameters: Canal straightening, Canal deviation and Instrumentation time.
Forghani, Maryam +2 more
core +1 more source
Transactions of Nonferrous Metals Society of China, 2014 Abstract The experimental analysis presented aims at the selection of the most optimal machining parameter combination for wire electrical discharge machining (WEDM) of 5083 aluminum alloy. Based on the Taguchi experimental design (L9 orthogonal array) method, a series of experiments were performed by considering pulse-on time, pulse-off time, peak ...
G. SELVAKUMAR +3 more
openaire +1 more source
Optimization Of Material Removal Rate And Surface Roughness Using The Taguchi Method [PDF]
, 2008 A non-conventional hybrid machining method called electrical discharge turning (EDT) process is optimized in this research. The EDT process is a suitable method to produce small components with cylindrical geometries.
Matoorian, Pooria
core
Effect of surface finishing on tribological properties of ZrO2-based composites [PDF]
, 2010 Laboratory-made ZrO2-based composites with 40 vol. % WC, TiCN or TiN were tested in dry sliding contact with WC-6wt%Co cemented carbide using an ASTM G133 pin-on-flat configuration.
Bonny, Koenraad +5 more
core
AN INNOVATIVE APPROACH TO REDUCING DEEP HOLE SHAPE DEVIATIONS
Nonconventional Technologies Review, 2016 The paper presents an innovative method for improving the shape precision of deep cylindrical holes, made by using WEDM (wire electrical discharge machining) technology. Following the presentation of some general aspects, the mathematical model of the
Calin Denes
doaj
Materials Research ExpressThis experimental study investigates the Wire-cut Electrical Discharge Machining (WEDM) of 20MnCr5 steel, a low alloy steel grade material which is intended for the production of gears, shafts and other parts which need high surface hardness and wear ...
N Vijayakumar, J Chandradass
doaj +1 more source
Wire electrical discharge machining of Ti-48Al intermetalic alloys using taguchi approach [PDF]
, 2006 This study investigates the wire electrical discharge machining (WEDM) of Ti- 48Al intermetallic alloys. Ti-48Al is intermetallic alloys which are categorized as lightweight material, posses greater strength and toughness are usually known to create ...
Kamsir, Abdul Sukur
core
Abrasive blast surface finish after the wire electrical discharge machining (WEDM) [PDF]
Mechanik, 2015 Lucjan Dąbrowski +2 more
openaire +1 more source
Process level environmental performance of electrodischarge machining of aluminium (3003) and steel (AISI P20) [PDF]
, 2016 Aalco +43 more
core +1 more source