Results 121 to 130 of about 6,690 (268)

Stable P‐Type PbS Quantum Dot Ink for all‐Blade‐Coated Short‐Wavelength Infrared Photodiodes

Advanced Materials, EarlyView.
Stabilization of p‐type PbS quantum dot ink is achieved through hydrogen bonding between fluorinated alcohols solvent and the MP ligand, allowing a six‐day shelf‐life. The solvent does not compromise pre‐deposited layers, enabling fully blade‐coated photodiodes in both n–p and p–n architectures, with enhanced detectivity and bandwidth compared to layer‐
Han Wang, Jiaxiong Li, Jacopo Pinna, Mordechai Kot, Noah Y. N. van der Ploeg, Maria A. Loi   +5 more
wiley   +1 more source

Large‐Area 2D Metasurface‐Based Triboelectric E‐Skin Arrays: Contact & Proximity Tactile Mapping with Broadband Acoustic Readouts

Advanced Materials, EarlyView.
Metasurface‐engineered NC‐TENG arrays integrate tactile pressure mapping, non‐contact gesture sensing, and acoustic signal readouts in one ultrathin module, and outperforms pristine PDMS in terms of electrical output and real‐time spatial mapping for next‐gen wearables.
Injamamul Arief, Swagato Sarkar, Anik Kumar Ghosh, Osvalds Verners, Kamal Kumar Meena, Su‐Hyeong Lee, Soosang Chae, Tobias A. F. König, Beate Krause, Andreas Fery, Mehmet Sait Özer, Anindya Nag, Amit Das   +12 more
wiley   +1 more source

Gradient‐Modified Li‐Rich Manganese‐Based Oxides Cathodes with Breakthrough of Kinetic Limitation for High‐Performance All‐Solid‐State Lithium Metal Batteries

Advanced Materials, EarlyView.
The novel gradient‐modified LRMO has been synthesized via a one‐step mechano‐fusion process, with simultaneous S and Zr co‐doping in the near‐surface region and an amorphous coating. The synergistic co‐functionalization stabilizes the oxygen framework, enhances charge transport, and suppresses oxygen dimerization under high potential, which enable ...
Ya Chen, Ling Huang, Awais Ghani, Xiaodong Chen, Xin Gao, Tao Meng, Hongchao Sun, Runjing Xu, Peiyi Ji, Xianghong Deng, Long Bao, Shuang Wang, Nana Wang, Gang Tan, Guoxiu Wang, Zhen Huang   +15 more
wiley   +1 more source

Nonmulberry Silk Fibroin Doping Boosts Charge Transfer and Charge Injection in Aligned Polypyrrole‐Silk Scaffolds for Low‐Voltage Neurostimulation

Advanced Materials Interfaces, EarlyView.
Conductive silk‐polypyrrole scaffolds couple redox stability with cell‐affinitive peptides present innately in an endogenous silk fibroin, enabling optimized electrical stimulation to drive neurite outgrowth. Findings establish electrochemical‐biological link for biomaterial design rules for smart nerve guidance conduits that can provide low voltage ...
Rajiv Borah, Joseph Christakiran Moses, Jnanendra Upadhyay, Jitu Mani Das, Michael G. Monaghan, Biman B. Mandal   +5 more
wiley   +1 more source

Secure transmission of correlated sources over broadcast channels with ultra-low latency

EURASIP Journal on Wireless Communications and Networking, 2019
Correlated sources passing through broadcast channels is considered in this paper. Each receiver has access to correlated source side information and each source at the sender is kept secret from the unintended receiver.
Hehe Chen, Ping Zhu
doaj   +1 more source

Fully Printed Organic Electrochemical Transistors With Low‐Resistance Electrodes on Planarized 3D‐Printed Substrates

Advanced Materials Technologies, EarlyView.
This paper explores integrating organic electrochemical transistors (OECTs) with planarized 3D‐printed substrates, utilizing ironing to enhance surface suitability for printing, dispense printing for thick, low‐resistance silver electrodes, and inkjet printing for semiconductor deposition.
Mohamad Kannan Idris, Ali Eskandari, Saumik Dey Shovan, Gerd Grau   +3 more
wiley   +1 more source

Strong Secrecy Capacity of a Class of Wiretap Networks

Entropy, 2016
This paper considers a special class of wiretap networks with a single source node and K sink nodes. The source message is encoded into a binary digital sequence of length N, divided into K subsequences, and sent to the K sink nodes respectively through ...
Dan He, Wangmei Guo
doaj   +1 more source

The Impact of Catalyst Layer Composition and Structure on Performance and Durability of PEMWE Anodes

Advanced Materials Technologies, EarlyView.
This article explores a new type of anode for water electrolysis that uses less iridium, a rare and expensive metal. By combining stable iridium oxide with platinum and carbon‐based materials, the authors create a catalyst layer that maintains strong performance.
Lena V. Bühre, Kaustubh Khedekar, Kimberly S. Reeves, Haoran Yu, Shaun M. Alia, Bryan S. Pivovar   +5 more
wiley   +1 more source

Lattice Structures for Bone Replacement: The Intersection of Bone Biomechanics, Lattice Design, and Additive Manufacturing

Advanced Materials Technologies, EarlyView.
This review outlines how understanding bone's biology, hierarchical architecture, and mechanical anisotropy informs the design of lattice structures that replicate bone morphology and mechanical behavior. Additive manufacturing enables the fabrication of orthopedic implants that incorporate such structures using a range of engineering materials ...
Stylianos Kechagias, Maxwell J. Munford, Frederik C.H. Masure, Richard J. van Arkel, Reece N Oosterbeek   +4 more
wiley   +1 more source

Characterization of Droplet Formation in Ultrasonic Spray Coating: Influence of Ink Formulation Using Phase Doppler Anemometry and Machine Learning

Advanced Materials Technologies, EarlyView.
This study explores how machine learning models, trained on small experimental datasets obtained via Phase Doppler Anemometry (PDA), can accurately predict droplet size (D32) in ultrasonic spray coating (USSC). By capturing the influence of ink complexity (solvent, polymer, nanoparticles), power, and flow rate, the model enables precise droplet control
Pieter Verding, Danny E. P. Vanpoucke, Yunus T. Aksoy, Tobias Corthouts, Maria R. Vetrano, Wim Deferme   +5 more
wiley   +1 more source