Plastic load evaluation for a fixed tube sheet heat exchanger subject to proportional loading [PDF]
, 2012 The plastic load of pressurised components can be calculated based on both the twice elastic slope and tangent methods. Both methods are problematic since they rely on parameters that are localised and therefore have a strong dependency on the gradient ...
Behseta, Khosrow +2 more
core +4 more sources
Evaluation of Interprofessional Practice Education for Master of Social Work Students [PDF]
, 2022 As interprofessional education (IPE) continues to grow as part of social work programs, it is important to evaluate how best to engage students in understanding this material and explore possible barriers.
Satre, Carol +3 more
core +1 more source
On Surface Grind Hardening Induced Residual Stresses [PDF]
, 2014 Grind hardening process utilizes the heat generated in the grinding area for the surface heat treatment of the workpiece. The workpiece surface is heated above the austenitizing temperature by using large values of depth of cut and low workpiece feed ...
Salonitis, Konstantinos
core +1 more source
Justification of the Changes in Work Hardening Exponent Based on Micro-Mechanisms of Deformation in a Plain Carbon Steel [PDF]
Archives of Metallurgy and MaterialsAlthough several studies have been conducted on the evaluation of work hardening behavior of dual-phase steels with the Hollomon equation, few studies have investigated the factors affecting the number of work hardening stages and the changes of work ...
M.S. Mohsenzadeh
doaj +1 more source
Metals, 2021 Engineering components are usually manufactured with sequential production processes. Work hardening due to previous production processes affects the machinability of the workpiece in subsequent operations. In this research, the surface work hardening of
Pingzhong Zhu +4 more
doaj +1 more source
Investigation of advanced strain-path dependent material models for sheet metal forming simulations [PDF]
, 2006 Sheet metal forming processes often involve complex loading sequences. To improve the prediction of some undesirable phenomena, such as springback, physical behavior models should be considered.
BALAN, Tudor +5 more
core +1 more source
Consequences of large strain anisotropic work-hardening in cold forging [PDF]
, 2021 The influence of anisotropic work-hardening on the component properties and process forces in cold forging is investigated. The focus is on the material behaviour exhibited after strain path reversals.
Hering, Oliver +2 more
core +1 more source
Impact of Short-Range Clustering on the Multistage Work-Hardening Behavior in Cu–Ni Alloys
Metals, 2019 The work-hardening behavior of Cu⁻Ni alloys with high stacking-fault energies (SFEs) is experimentally investigated under uniaxial compression. It is found that, with the increase of Ni content (or short-range clustering, SRC), the flow stress of ...
Dong Han +4 more
doaj +1 more source
Frontiers in Materials, 2021 The yielding of a high Mn twinning-induced plasticity steel was examined in three fine-grained specimens recrystallized at 700°C for 5 min with different cooling conditions.
Singon Kang, Sujin Jeong, Yeon-Sang Ahn
doaj +1 more source
Contribution of Different Hardening Mechanisms during Cold Working of AISI 304L Austenitic Stainless Steel [PDF]
Archives of Metallurgy and Materials, 2018 The contributions of work-hardening of austenite and the presence of martensite on the hardening of an AISI 304L stainless steel were evaluated based on plastic deformation under different reductions in thickness at two rolling temperatures.
T. Mirzaie, H. Mirzadeh, M. Naghizadeh
doaj +1 more source