Fabrication of Ordered SnO2 Nanostructures with Enhanced Humidity Sensing Performance
Sensors, 2017 Ordered SnO2 nanostructures were prepared as humidity sensors by nanosphere lithography with the magnetron sputtering technique. The X-ray diffraction patterns of SnO2 nanostructures show that all intense diffraction peaks correspond to the ...
Wei Li +6 more
doaj +1 more source
VETA-I x ray test analysis [PDF]
This interim report presents some definitive results from our analysis of the VETA-I x-ray testing data. It also provides a description of the hardware and software used in the conduct of the VETA-I x-ray test program performed at the MSFC x-ray ...
Brissenden, R. J. V. +7 more
core +1 more source
Microphotonic parabolic light directors fabricated by two-photon lithography [PDF]
, 2011 We have fabricated microphotonic parabolic light directors using two-photon lithography, thin-film processing, and aperture formation by focused ion beam lithography. Optical transmission measurements through upright parabolic directors 22 μm high and 10
Atwater, H. A. +8 more
core +1 more source
Comment on "Quantum Interferometric Optical Lithography: Exploiting Entanglement to Beat the Diffraction Limit" [PDF]
arXiv, 2003 Comment on "Quantum Interferometric Optical Lithography: Exploiting Entanglement to Beat the Diffraction Limit" The effective absorption rates in quantum lithography are very low.
arxiv
Fabrication of ultrathin suspended polymer membranes as supports for serial protein crystallography
Micro and Nano Engineering, 2020 We present a process sequence for the fabrication of ultrathin perforated membranes suspended in polymer frames. Nanoimprint lithography was used to imprint high-density pillar arrays into a double layer consisting of 300 nm of water-soluble PVP and 2–3 ...
Agnieszka Karpik +3 more
doaj
Heavy electrons: Electron droplets generated by photogalvanic and pyroelectric effects
, 2009 Electron clusters, X-rays and nanosecond radio-frequency pulses are produced by 100 mW continuous-wave laser illuminating ferroelectric crystal of LiNbO_3.
Beckmann P. +13 more
core +1 more source
Fabrication of Oblique Submicron-Scale Structures Using Synchrotron Hard X-ray Lithography. [PDF]
Polymers (Basel), 2021 Kim K +9 more
europepmc +1 more source
Fabricating Blazed Diffraction Gratings by X-Ray Lithography [PDF]
Gray-scale x-ray lithography is undergoing development as a technique for fabricating blazed diffraction gratings. As such, gray-scale x-ray lithography now complements such other grating-fabrication techniques as mechanical ruling, holography, ion ...
Hartley, Frank +2 more
core +1 more source
Enhancement of optical response in nanowires by negative-tone PMMA lithography
, 2018 The method of negative-tone-PMMA electron-beam lithography is investigated to improve the performance of nanowire-based superconducting detectors. Using this approach, the superconducting nanowire single-photon detectors (SNSPDs) have been fabricated ...
Agarwal, Akshay +3 more
core +1 more source
AIP Advances, 2016 By combining mask-less lithography and chemical vapor deposition (CVD) techniques, a novel two-stage diamond anvil has been fabricated. A nanocrystalline diamond (NCD) micro-anvil 30 μm in diameter was grown at the center of a [100]-oriented, diamond ...
Gopi K. Samudrala +5 more
doaj +1 more source