Studying and comparing the erosion-enhanced pitting corrosion of X52 and X100 steels
International Journal of Electrochemical Science, 2012 The critical ratio of Cl− to HCO− concerning the corrosion rate has been determined with and without electrolyte erosion in 0.3 M NaHCO3 by using various concentrations of NaCl for X52 and X100 steels.
A. Rauf, E. Mahdi
doaj +1 more source
Automated measurements of retinal bifurcations [PDF]
, 2009 This paper presents an analysis of the bifurcations of retinal vessels. The angles and relative diameters of blood vessels in 230 bifurcations were measured using a new automated procedure, and used to calculate the values of several features with known ...
Al-Diri, Bashir, Hunter, Andrew
core +1 more source
Combined numerical-experimental framework for strain based design and flaw assessment of girth welds [PDF]
, 2013 An increasing number of transmission pipelines have to be installed and operated in harsh conditions, due to the diminishing reserves of exploited fossil fuel sources.
De Waele, Wim +4 more
core +2 more sources
Widespread abiotic methane in chromitites [PDF]
, 2018 Recurring discoveries of abiotic methane in gas seeps and springs in ophiolites and peridotite massifs worldwide raised the question of where, in which rocks, methane was generated.
Etiope, G. +8 more
core +1 more source
Effect of pH Value on the Corrosion Behavior of X100 Pipeline Steel in Simulated Seawater [PDF]
Cailiao BaohupH value is one of the important factors affecting corrosion in marine environment.The effects of pH value on the corrosion behavior of X100 pipeline steel in simulated seawater were investigated using kinetic potential polarization curves ...
QI Bin, LI Jidong, ZHANG Ying, CHEN Dongxu, HUANG Xinglin, WANG Yiyong
doaj +1 more source
International Journal of Electrochemical Science, 2020 The alternating current (AC) corrosion behavior of X100 steel was studied in Golmud soil simulated solution with different pH using electrochemical measurement, immersion test and surface analysis technology.
Jinlin Yang +6 more
doaj +1 more source
Effect of Quench Tempering on Hydrogen Embrittlement and Corrosion Behavior of X100 Pipeline Steel
Metals, 2023 In this study, the hydrogen embrittlement and corrosion behavior of X100 pipeline steel (Ref) was investigated after various heat treatments, including one-step austenitizing at 880 °C (HT3), 830 °C (HT2), and 780 °C (HT1) for 90 min, oil quenching to ...
Reza Khatib Zadeh Davani +5 more
doaj +1 more source
A Comparison of Cathodic Protection Parameters with High- Strength Pipeline Steels in Soil Solution
International Journal of Electrochemical Science, 2014 Cathodic protection is usually used to control the corrosion in service pipeline. The optimum cathodic protection potential (OCPP) becomes a vital part in order to get the best protective effect in the whole research of cathodic protection.
Xinhua Wang +3 more
doaj +1 more source
Erosion Behaviour of API X100 Pipeline Steel at Various Impact Angles and Particle Speeds
Metals, 2016 Erosion is the gradual removal of material due to solid particle impingement and results in a failure of pipeline materials. In this study, a series of erosion tests were carried out to investigate the influence of particle speed and impact angle on the ...
Paul C. Okonkwo +3 more
doaj +1 more source
Surface damage resulting from rolling contact operating in magnetic field [PDF]
, 2007 This paper describes the effects of magnetic field in rolling contact tests of steel by using a two-disc configuration and the investigation of mechanisms involved.
Iida, Y, Sato, K, Stolarski, T A
core +1 more source