Results 41 to 50 of about 753,619 (341)

Influence of matrix toughness and interfacial strength on the toughness of epoxy composites with ductile steel fabric reinforcement [PDF]

open access: yes, 2015
In the last decades, several studies have been performed on polymers reinforced with steel cords or wires. However, the diameter of these steel reinforcements was still quite large (200 micron and more).
Degrieck, Joris   +3 more
core   +2 more sources

Influence of yarn folding on UV protection properties of hemp knitted fabrics [PDF]

open access: yesHemijska Industrija, 2016
In the last years the media have highlighted the damage of the ozone layer and the resulting increase of ultraviolet radiation (UVR) reaching the earth’s surface.
Kocić Ana A.   +3 more
doaj   +1 more source

Enhancing the quality of elastane-cotton core yarn by compact spinning

open access: yesHeliyon, 2022
The quest for highly stretchable fabrics with good aesthetic and functional properties has led researchers to constantly involve in mingling of natural and synthetic fibers.
Md. Ikramul Islam, Ahmed Jalal Uddin
doaj   +1 more source

Nano-yarn carbon nanotube fiber based enzymatic glucose biosensor [PDF]

open access: yes, 2010
This is the author's accepted manuscript. The final published article is available from the link below. Copyright @ 2010 IOP Publishing Ltd.A novel brush-like electrode based on carbon nanotube (CNT) nano-yarn fiber has been designed for electrochemical ...
Bard A J   +8 more
core   +1 more source

Structural mass irregularities and fiber volume influence on morphology and mechanical properties of unsaturated polyester resin in matrix composi

open access: yesJournal of Advanced Research, 2015
This paper presents the comparative results of a current study on unsaturated polyester resin (UPR) matrix composites processed by filament winding method, with cotton spun yarn of different mass irregularities and two different volume fractions ...
Khalil Ahmed   +4 more
doaj   +1 more source

Effect of polyester and elastane linear density on the physical and mechanical properties of dual-core-spun cotton yarns

open access: yesJournal of Natural Fibers, 2020
The use of single-core elastic spun cotton yarns is well established in textiles and denim industry but interest in the use of dual-core-spun yarns has started to grow only recently.
Abdul Jabbar   +5 more
doaj   +1 more source

Effect of Elastane Plating on Physical & Thermal Comfort Properties of Lyocell Single Jersey Knit Fabric with Different Loop Length

open access: yesJournal of Natural Fibers, 2022
Elastic weft knitted single jersey fabrics are produced by plating of elastane (elastomeric polyurethane) yarn with lyocell yarn in a circular knitting machine with positive feeder.
P C Shobanasree   +3 more
doaj   +1 more source

Fatigue crack growth in thin notched woven glass composites under tensile loading. Part II: modelling [PDF]

open access: yes, 2011
Fatigue propagation of a through-the-thickness crack in thin woven glass laminates is difficult to model when using homogeneous material assumption. Crack growth depends on both the fatigue behaviour of the fibres and of the matrix, these two phenomena ...
Barrau, Jean-Jacques   +3 more
core   +3 more sources

Investigation of Some Physical Properties of Knitted Fabrics Produced from Macaroni Yarns

open access: yesFibres and Textiles in Eastern Europe, 2018
Recently there have been new trends in fancy yarns in order to meet consumer demands for drapery, decorative and outwear fabrics. Macaroni yarns are a promising group of fancy yarn which allows new yarn designs with different raw materials at different yarn counts. In the study, supreme knitted fabrics were produced with macaroni yarns of different raw
Çeven, E.K., Günaydın, Gizem Karakan
openaire   +4 more sources

Characterization of Low Twist Yarn: Effect of Twist on Physical and Mechanical Properties [PDF]

open access: yesMehran University Research Journal of Engineering and Technology, 2012
The amount of twist plays vital role for finished consumers\' good which determines appearance, durability and serviceability of fabric. In this research, yarns made of four twists (170, 190, 210 and 230 tpm (turns per meter) were investigated in order
Sadaf Aftab Abbasi   +2 more
doaj  

Home - About - Disclaimer - Privacy