Results 11 to 20 of about 3,511,649 (249)
Punching shear strength of steel fibre reinforced lightweight concrete slabs. [PDF]
, 1981 One of the problems in slab-column connections is the punching shear failure at over loads. Such failures are sudden and catastrophic, and are undesirable since they do not allow an overall yield mechanism to ...
Theodorakopoulos, Dimitrios D.
core +6 more sources
Safe structural design for fatigue and creep using cyclic yield strength [PDF]
, 2014 This study proposes cyclic yield strength (CYS, σ_cy) as a potential characteristic of safe design for structures operating under fatigue and creep conditions.
Gorash, Yevgen, Mackenzie, Donald
core +3 more sources
Metals, 2020 Titanium aluminide (TiAl) is one of the most promising materials for aerospace applications. It is a suitable replacement for nickel-based superalloys predominantly used in these applications.
A. Raja Annamalai +5 more
doaj +1 more source
Study on Pressure Release Performance of a New Type of Anchor Cable Pressure Release Device
Meikuang Anquan, 2020 This paper presents a new type of anchor cable pressure release device, which is composed of the pressure release pipe and the pressure plug. The device is installed between the support plate and the lock, no reaming is required, and it has low cost ...
WU Yuyi
doaj +1 more source
Metals, 2018 The effects of warm rolling reduction ratio ranging from 20% to 55% on microstructure evolution, the tensile deformation mechanism, and the associated mechanical properties of an Fe-30Mn-4Si-2Al TRIP/TWIP steel were studied.
Yanchun Dong +10 more
doaj +1 more source
High Temperature Materials and Processes, 2021 HRB500E seismic steel bars are mainly used in high-rise buildings near the seismic zone. The influence of different niobium contents (0–0.023%) on the microstructure and mechanical properties of HRB500E seismic reinforcement was studied.
Huang Sheng +7 more
doaj +1 more source
Royal Society Open Science, 2023 The feeding apparatus of sea turtles comprises cornified keratinous rhamphothecae overlaying a bony rostrum. Although keratin is less stiff than the enamel of toothed animals, certain species of sea turtles are capable of withstanding large forces when ...
Danielle N. Ingle +3 more
doaj +1 more source
Metals, 2022 The work hardening behavior of α + θ UFG steel related to α + θ two phase microstructure is more complicated than that of single-phase materials. Very few studies have been conducted on the work hardening of α + θ UFG steels.
Zhoutou Wang +4 more
doaj +1 more source
Experimental Research on the Cold-Forming Effect of Cold-Formed Thick-Walled Steel
Buildings, 2023 To study the cold-forming effect on the yield strength distribution of cold-formed thick-walled steel, material tensile tests and axial compression tests were conducted on steel-lipped channels. To undertake the material tensile tests, five types of cold-
Xiaochao Fu +3 more
doaj +1 more source
PERANCANGAN METODE MACHINE LEARNING BERBASIS WEB UNTUK PREDIKSI SIFAT MEKANIK ALUMINIUM
Rekayasa Mesin, 2023 The main objective of this research is to design a web-based machine learning model that can predict the mechanical properties of aluminum based on its chemical composition. By inputting nine variables of chemical elements such as Al, Mg, Zn, Ti, Cu, Mn,
Desmarita Leni +5 more
doaj +1 more source