Results 301 to 310 of about 6,926,535 (359)
Some of the next articles are maybe not open access.
Yield Strength Prediction of Titanium Alloys
JOM, 2015A confidence interval on the yield strength prediction for wrought titanium alloy Ti-6Al-4V is presented, statistically estimated from a recently developed phenomenological model relating the material parameters to material properties. In this study, the material composition and microstructure parameters were statistically characterized using ...
C. V. Haden, P. C. Collins, D. G. Harlow
openaire +1 more source
On Strength at Yield in Condensed Matter
Metallurgical and Materials Transactions A, 2014This paper concerns the lower of a range of thresholds that control the response of condensed matter under loading in compression, from the ambient laboratory state to the point at which the bond strength is overcome and warm dense matter is formed.
openaire +1 more source
Yield strength of attached copper film
Chinese Physics B, 2011Variation of stress in attached copper film with an applied strain is measured by X-ray diffraction combined with a four-point bending method. A lower slope of the initial elastic segment of the curve of X-ray measured stress versus applied strain results from incomplete elastic strain transferred from the substrate to the film due to insufficiently ...
Yan Zhang, Jian-Min Zhang
openaire +1 more source
Assessment of yield strength mismatch in X80 pipeline steel welds using instrumented indentation
International Journal of Pressure Vessels and Piping, 2018Strain-based design (SBD) of pipelines allows stress owing to displacement-controlled loads originating from landslides, seismic motions, or frost heaves, to exceed yield stress.
A. Midawi, C. Simha, A. Gerlich
semanticscholar +1 more source
Inelastic yielding strength demand coefficient spectra
Soil Dynamics and Earthquake Engineering, 2008Abstract Currently, earthquake action is obtained by dividing the elastic acceleration spectra by a seismic modification factor, and the latter is also a spectrum actually. The dynamic inelastic response of single-degree-of-freedom (SDOF) systems for modified-Clough hysteretic model with stiffness degradation when subjected to reverse loading were ...
Genshu Tong, Yongfeng Zhao
openaire +1 more source
Withdrawal Strength and Bending Yield Strength of Stainless Steel Nails
Journal of Structural Engineering, 2015AbstractIt has been well established that stainless steel nails have superior corrosion performance compared to carbon steel or galvanized nails in treated wood; however, their mechanical fastening behavior is unknown. In this paper, the performance of stainless steel nails is examined with respect to two important properties used in wood connection ...
Douglas R. Rammer, Samuel L. Zelinka
openaire +1 more source
A Rational Definition of Yield Strength
The Journal of the Royal Aeronautical Society, 1940Explicitly or implicitly the yield strength of a material is often used as a measure of incipient structural damage. With the yield strength determined by conventional methods, however, it cannot be said in general for two structural elements geometrically alike but of different materials that similar loads, producing maximum stresses equal to the ...
openaire +1 more source
On the yield strength of diamond
Journal of Applied Physics, 1979This paper describes how the yield stress of strong single crystals can be estimated from the Hugoniot elastic limit and the second- and third-order elastic constants. Data on germanium and silicon are analyzed. The dynamic yield stresses obtained are compared with a directly measured static value for silicon and for values obtained from Knoop hardness
openaire +1 more source
Dynamic Yield Strength and Spall Strength of Polycrystalline Nickel Aluminide
Physical Mesomechanics, 2022V.V. Yakushev +4 more
openaire +1 more source