Results 81 to 90 of about 42,173 (288)
Effect of Additional Mass on the Apparent Young’s Modulus of a Wooden Bar by Longitudinal Vibration
We investigated the influence of an additional mass bonded on a wooden bar on its apparent Young’s modulus based on a longitudinal vibration theory. Rectangular bars of Sitka spruce (Picea sitchensis Carr.) were used as experimental materials.
Yoshitaka Kubojima +2 more
doaj +1 more source
Recent studies have indicated that the addition of a diluent significantly affect its mechanical properties and performance of a coating, but no works have been reported on the influence of diluent content on the Young’s modulus of a coating, and the ...
Chao Xie +4 more
doaj +1 more source
Determination of Young’s Modulus of Ultrathin Nanomaterials
Determination of the elastic modulus of nanostructures with sizes at several nm range is a challenge. In this study, we designed an experiment to measure the elastic modulus of amorphous Al2O3 films with thicknesses varying between 2 and 25 nm. The amorphous Al2O3 was in the form of a shell, wrapped around GaAs nanowires, thereby forming an effective ...
Chen, Yujie +9 more
openaire +5 more sources
Enhanced Strength and Corrosion Resistance of Ti‐13Nb‐12Ta‐10Zr‐4Sn Alloy by Aging Treatment
This work systematically investigates the effect of aging treatment on mechanical properties and corrosion behavior of vacuum arc‐melted Ti‐13Nb‐12Ta‐10Zr‐4Sn alloy. Owing to the increased α″ martensite, strength and corrosion resistance were significantly enhanced by aging treatment.
Yuhua Li +5 more
wiley +1 more source
MEMS Young's modulus and step height measurements with round robin results
This paper presents the results of a microelectromechanical systems (MEMS) Young's modulus and step height round robin experiment, completed in April 2009, which compares Young's modulus and step height measurement results at a number of laboratories ...
Marshall, J; Allen, RA; McGray, CD; Geist, J
core +1 more source
This plot compares experimental tensile stress–strain curves (with 4 different strain rates) and corresponding modelled curves (obtained using the optimised sets of Voce and Miller–Norton parameter values shown). The inferred M‐N values, characterizing the creep, are very similar to those obtained via conventional creep testing.
S. Ooi, R. P. Thompson, T. W. Clyne
wiley +1 more source
Caracterização de constantes elásticas de materiais isotrópicos por holografia óptica eletrônica combinada ao método de ressonância mecânica / [PDF]
Dissertação (Mestrado) - Universidade Federal de Santa Catarina, Centro ...
Suterio, Ricardo
core
AFC varied with viscosity or Young's modulus.
(A) Changing curve with viscosity. (B) Changing curve with Young's modulus.
Jianwen Luo (1651273) +7 more
core +1 more source
Graphene nanoplatelet (0.1 wt.%) reinforcement significantly enhances the performance of β Ti‐28Nb‐35.4Zr alloy. Grain refinement, reduced water contact angle, and improved surface characteristics promote osteoblast adhesion and complete surface coverage after 7 days.
Khurram Munir +5 more
wiley +1 more source
Techniques for Studying Materials: Virtual experiment for Young's modulus
This animation presents a virtual experiment for Young's modulus.
DoITPoMS, University of Cambridge +2 more
core

