Results 121 to 130 of about 12,799 (240)

Characterization of Cracks and their Effects on the Effective Transport Pathways in Ni-YSZ Anodes after Reoxidation Using X-Ray Nanotomography

open access: yes
Reduction-oxidation cycling of Ni-based electrodes for solid oxide fuel/electrolysis cells irreversibly alters their microstructure and can cause the fracture of the electrolyte.
Cocco, A. P.   +14 more
core   +1 more source

Co-sintering of dense electrophoretically deposited YSZ films on porous NiO-YSZ substrates for SOFC applications [PDF]

open access: yes, 2005
An original process for the preparation of YSZ dense films with a thickness lower than 10 μm over NiO-YSZ substrates is presented. This process involves the preparation of a green membrane of NiO-YSZ and subsequent electrophoretic deposition (EPD) of ...
Savo, G   +8 more
core  

LSM-YSZ Reactions in Different Atmospheres

open access: yes, 2009
The influences of the oxygen partial pressure and the LSM/YSZ ratio on the LSM-YSZ interface reactions at 1,000 °C were investigated. Both pellets and diffusion couples were employed in the study.
Poulsen, Finn Willy   +9 more
core   +1 more source

Preparation of Electrolyte Based on YSZ Material at the Green Boundary of NiO-YSZ

open access: yesInternational Research Journal of Innovations in Engineering and Technology
The development of alternative energy technologies, particularly based on fuel cells, has become a primary focus in material research for energy applications. Solid Oxide Fuel Cells (SOFCs) are promising due to their high efficiency, fuel flexibility, and relatively low environmental impact.
Muhammad Faesal Febriandyono   +5 more
openaire   +1 more source

OsCPN10a, cooperating with OsCPN20 and OsHSP60‐3B negatively regulate ABA signaling and enhance seed storability in rice

open access: yesJournal of Integrative Plant Biology, Volume 68, Issue 7, Page 2242-2263, July 2026.
Abscisic acid signaling homeostasis is essential for seed storability. The molecular chaperone OsCPN10a enhances rice seed storability by forming a trimeric chaperone complex with OsCPN20‐OsHSP60‐3B that attenuates abscisic acid signaling via direct interaction with OsPYL10‐OsABIL1, thereby maintaining starch integrity and offering a promising target ...
Sufeng Liao   +13 more
wiley   +1 more source

Pressurized Solid Oxide Fuel Cells: Operational Behavior

open access: yes, 2011
The operational behavior of SOFC short stacks at elevated pressures up to 7 bar was examined. The experiments were performed on planar, anode-supported 5-cell short stacks.
Maier , Uwe   +7 more
core  

Physical and Electrical Properties of Yttria-Stabilized Zirconia Thin Films Prepared by Radio Frequency Magnetron Sputtering

open access: yesActa Polytechnica, 2013
This paper presents the electrophysical characteristics of a 7 mol.% yttria-stabilized zirconia (YSZ) thin film deposited by radio-frequency magnetron sputtering.
Dmitriy A. Golosov   +2 more
doaj  

Pengaruh komposisi dan variasi jumlah sapuan komposit YSZ-Al2O3 terhadap ketahanan termal dan kekuatan lekat pada YSZ/YSZ-AL2O3 double layer TBC untuk aplikasi nosel roket [PDF]

open access: yes, 2015
TBC (Thermal Barrier Coating) dengan YSZ/Al2O3-YSZ top coat (TC) dan MCrAlY sebagai bond coat (BC) yang selanjutnya disebut sebagai YSZ/Al2O3-YSZ double layer TBC digunakan sebagai aplikasi material perintang panas pada dinding dalam nosel roket ...
Agustina, Ratna Tri
core  

Electrical conductivity of thick film YSZ

open access: yes, 2019
When yttria-stabilized zirconia (YSZ) electrolyte is coated and co-sintered on top of Ni-YSZ anode support, the measured conductivities of YSZ thick films (10-30 mu m thick) are often lower than that of bulk YSZ.
Kwon, OH, Choi, GM
core   +1 more source

Improving high temperature corrosion resistance of Cr3C2–25NiCr coating by incorporating nano yttria-stablized zirconia

open access: yesDiscover Materials
The hot corrosion behavior of Cr3C2–25NiCr composite coatings reinforced with nano yttria stabilized zirconia (YSZ) was evaluated under actual boiler conditions in a thermal power plant at 850 °C with cyclic thermal loading.
Sukhjinder Singh   +2 more
doaj   +1 more source

Home - About - Disclaimer - Privacy