Results 221 to 230 of about 160,250 (344)

Phenomenological and Physically Based Modeling of Flow Stress and Strengthening Mechanism of Inconel 718

Advanced Engineering Materials, EarlyView.
Nickel‐based alloys are widely used in high‐temperature applications due to their excellent mechanical strength and oxidation resistance. However, properties such as high‐temperature strength and pronounced work‐hardening make them difficult to machine.
Soheil Rooein, Oliver Schenk, Christoph Broeckmann   +2 more
wiley   +1 more source

Active line model identification protection based on characteristic frequency phase for dual-end weakly-fed AC system. [PDF]

Sci Rep
Hou J, Zhang Z, Fan Y, Song G, Wu X.
europepmc   +1 more source

Composition‐Tuned Enhancement of the Anomalous Nernst Effect in FeCo–Pt Thin Films on Rigid and Flexible Substrates

Advanced Engineering Materials, EarlyView.
Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi, Hiroyuki Awano, Kenji Tanabe   +2 more
wiley   +1 more source

Current sensorless MPPT method with battery management for PV based single phase standalone system. [PDF]

Sci Rep
Genc N, Uzmus H, Kalimbetova Z, Celik MA, Ramankulov S.   +4 more
europepmc   +1 more source

On the Influence of Antioxidants and Recycled MgO–C Source Material on the Mechanical Properties of Carbon‐Bonded Magnesia Refractories

Advanced Engineering Materials, EarlyView.
The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann, Tom Weber, Jana Hubálková, Florian Kerber, Dinesh Kumar Gunasekar, Hans Jelitto, Christos G. Aneziris   +6 more
wiley   +1 more source

A high efficiency active X²G boost converter with hybrid optimized proportional integral controller for PV powered EV charging applications. [PDF]

Sci Rep
Chandrasekar G, Lakshmanan SA.
europepmc   +1 more source

Quasi‐Z‐source interleaved DC‐DC converter for fuel cell vehicle application

Reza Rashid, Alfred Baghramian, Hamed Mojallali   +2 more
openalex   +1 more source

A Modified Isolated Z‐Source AC–AC Converter With Inherent Commutation and Reduced Polarity Changer Switches [PDF]

Deniz Zargariafshar, Mehran Sabahi, Mohammad Bagher Bannae Sharifian, Ebrahim Babaei   +3 more
openalex   +1 more source

CONTROL OF THREE PORT DC-DC CONVERTER FOR QUASI Z SOURCE INVERTER BASED GRID CONNECTED PV-BATTERY APPLICATION

, 2020
SAMBANDHAMOORTHY VIJAYAKUMAR, K Jayasurya, G Nishanth, U Saranraj   +3 more
openalex   +1 more source

Four‐Point Bending Tests at High Temperatures on Commercial MgO‐C Refractory Bricks with and Without Recyclate Considering Different Carbon Contents

Advanced Engineering Materials, EarlyView.
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm, Lukas Knöchel, Thomas Schemmel, Christos G. Aneziris, Anja Weidner, Horst Biermann   +5 more
wiley   +1 more source