Results 41 to 50 of about 675 (173)
A Novel Soft-Switched SEPIC-Based DC–DC Converter With High Voltage Gain
This study introduces a novel high-gain DC-DC converter by integrating a coupled inductor (CI) and a voltage multiplier cell (VMC) into the conventional SEPIC topology.
Reza Asgarnia +3 more
doaj +1 more source
This paper adopts a Neutral‐Point‐Clamped H‐bridge (NPC‐H) DAB topology to mitigate voltage stress on the input‐side switches. For both charging and discharging scenarios, a direct current control method is proposed using the output current as the primary control variable.
Yunxiang Jiang +3 more
wiley +1 more source
DESAIN DAN IMPLEMENTSI SOFT SWITCHING BOOST KONVERTER DENGAN SIMPLE AUXILIARY RESONANT SWITCH (SARC)
Boost konverter merupakan penaik tegangan DC ke tegangan DC yang mempunyai tegangan output yang lebih tinggi dibanding inputnya. Penggunaan boost konverter diera modern semakin meningkat dan dibuat dengan dimensi yang lebih kecil, berat yang lebih ringan
Dimas Bagus Saputra +2 more
doaj
Direct current (DC)–DC converters are the backbone of electric vehicle (EV) power trains, enabling efficient and bidirectional energy flow between the battery, high‐voltage (HV) DC link, and auxiliary rails under tight isolation, gain, ripple, and electromagnetic interference (EMI) constraints.
Abhilash Sakhare +3 more
wiley +1 more source
Hybrid DC Converter with Current Sharing and Low Freewheeling Current Loss
A new hybrid high-frequency link pulse-width modulation (PWM) converter using voltage balance capacitor and current balance magnetic coupling is proposed to realize low freewheeling current loss and wide load range of soft switching operation.
Bor-Ren Lin, Guan-Yi Wu
doaj +1 more source
Energy Management of a Fuel Cell–Supercapacitor Hybrid System With Dedicated Charging Converter
This paper proposes a coordinated energy management system (EMS) for a fuel cell–supercapacitor hybrid system interfaced through three isolated dual active bridge (DAB) converters. The proposed approach enhances system efficiency by reducing the number of power conversion stages and improving power flow coordination between the fuel cell and ...
Faheem Ijaz +3 more
wiley +1 more source
Tegangan tinggi tidak hanya digunakan untuk keperluan transmisi, tetapi juga untuk penelitian di laboratorium. Pada umumnya, tegangan tinggi dibangkitkan menggunakan pembangkit tegangan tinggi konvensional yang berukuran besar. Oleh karena itu, diperlukan rangkaian yang lebih sederhana untuk membangkitkan tegangan tinggi, misalnya menggunakan konverter
Novy Arizka Pratiwi +2 more
openaire +2 more sources
This paper proposes a high‐power hydrogen converter specifically designed for megawatt‐level (MW‐scale) off‐grid hydrogen production systems powered by renewable energy sources. A two‐stage ISOP architecture is adopted to fulfill the demanding requirements of high voltage step‐up, high efficiency, low output ripple, and reliable power regulation.
Rui Zhou +4 more
wiley +1 more source
Improved Efficiency of Two‐Stage Partial Power Processing Architectures for Inductive Power Transfer
This paper proposes a high‐efficiency two‐stage inductive power transfer (IPT) system with partial power processing to reduce energy losses in conventional cascaded architectures. By processing only partial power through the DC/DC converter, the system minimizes losses, lowers component stress, and improves power density.
Hang Lu, Jiyao Wang
wiley +1 more source
A Study on a Phase-Shift Controlled ZVS DC-DC Converter with a Synchronous Rectifier
The paper presents a study on a phase-shift controlled zero-voltage switching (ZVS) full-bridge DC-DC converter employing synchronous rectification using the LTC3722-1 controller.
Tsvetana Grigorova +2 more
doaj +1 more source

