Results 41 to 50 of about 241 (98)
Auxiliary Inverter with Zero-current Soft Switching DC/DC Converter Input
机车电传动, 2014 An auxiliary inverter with zero-current soft switching DC/DC converter input was proposed. Two-stage transformer circuit structure was adopted, the front part of which was DC/DC converter, and the rear part of which was three-phase inverter circuit. Zero-
GAO Yongjun, ZHANG Ruifeng
doaj
A ZVT Auxiliary Circuit for High Step-Up Multi-Input Converters with Diode-Capacitor Multiplier
Majlesi Journal of Electrical EngineeringIn this paper, a Zero-Voltage Transition (ZVT) non-isolated high step-up multi-input DC-DC converters is proposed which employs an auxiliary cell and diode-capacitor multiplier.
Sayed Hossein Mirlohi +2 more
doaj +1 more source
Simulation and Implementation a Non-Isolated Buck Converter at ZCS Condition [PDF]
Journal of Intelligent Procedures in Electrical Technology, 2013 A new soft-switching resonant inverting-buck converter with high efficiency is presented. The proposed converter steps down and inverts the input voltage.
Nahid Hematian, Masoud Jabari
doaj
IET Electric Power Applications, Volume 20, Issue 1, January/December 2026.This paper adopts a Neutral‐Point‐Clamped H‐bridge (NPC‐H) DAB topology to mitigate voltage stress on the input‐side switches. For both charging and discharging scenarios, a direct current control method is proposed using the output current as the primary control variable.
Yunxiang Jiang +3 more
wiley +1 more source
IET Renewable Power Generation, 2023 In this paper a new topology of non‐isolated high step‐up DC‐DC is proposed for renewable applications like photovoltaic (PV) power generation. This converter is designed based on coupled inductor and VMC techniques.
Seyed Majid Hashemzadeh +3 more
doaj +1 more source
IET Electrical Systems in Transportation, Volume 2026, Issue 1, 2026.Direct current (DC)–DC converters are the backbone of electric vehicle (EV) power trains, enabling efficient and bidirectional energy flow between the battery, high‐voltage (HV) DC link, and auxiliary rails under tight isolation, gain, ripple, and electromagnetic interference (EMI) constraints.
Abhilash Sakhare +3 more
wiley +1 more source
Iranian Journal of Electrical and Electronic Engineering, 2016 In this paper, a new bidirectional buck-boost dc-dc converter with capability of soft switching and zero input current ripple is proposed. The coupled inductor is used in the proposed converter to eliminate the input current ripple.
E. Babaei, Z. Saadatizadeh, S. Laali
doaj
A Novel Fully Soft‐Switching DC–DC High Step‐Up Converter With Integrated Auxiliary Circuit
The Journal of EngineeringThis paper introduces a new high step‐up converter based on an interleaved structure. The topology achieves high efficiency by eliminating switching losses and reducing conduction losses.
Arsalan Erfani +2 more
doaj +1 more source
Energy Management of a Fuel Cell–Supercapacitor Hybrid System With Dedicated Charging Converter
IET Generation, Transmission &Distribution, Volume 20, Issue 1, January/December 2026.This paper proposes a coordinated energy management system (EMS) for a fuel cell–supercapacitor hybrid system interfaced through three isolated dual active bridge (DAB) converters. The proposed approach enhances system efficiency by reducing the number of power conversion stages and improving power flow coordination between the fuel cell and ...
Faheem Ijaz +3 more
wiley +1 more source
IET Power Electronics, 2022 The switched‐capacitor DC‐DC converters have been widely applied to convert energy from low voltage to DC bus for the power generation systems with fuel cells, photovoltaic array, and so on.
Yangbin Zeng +3 more
doaj +1 more source