Results 81 to 90 of about 3,136 (196)

Designing Dual-Active Bridge (DAB) converter for energy storage/recovery systems in a lighting smart grid context [PDF]

open access: yes, 2014
Lighting Systems are suffering and important evolution with the introduction of LED lighting systems with new strategies of energy savings, incorporation of renewable energy sources and optionally a bidirectional interconnection with the mains (AC grid ...
Calleja Rodríguez, Antonio Javier   +3 more
core   +1 more source

Development and Efficiency Analysis of Dual Active Bridge Converter Employing SiC Devices Using TMS 320F280039

open access: yesIET Circuits, Devices &Systems, Volume 2025, Issue 1, 2025.
The utilization of on‐board chargers (OBCs) in electric vehicle (EV) has become increasing prevalent due to their configuration and cost‐efficiency in the context of installation. Furthermore, the automobile industry is increasingly showing interest in bidirectional power flow because of the EV’s ability to provide energy back to the network. The paper
T. Deepti   +6 more
wiley   +1 more source

Delay effects on the limit cycling behavior in an H-bridge resonant inverter with zero current switching control strategy [PDF]

open access: yes, 2018
Celebrado en Tarragona del 2-6 de septiembre de 2018.In this paper, bifurcations of limit cycles in a H-bridge LC resonant inverter under a zero current switching control strategy with delay in the switching action are analyzed. Mathematical analysis and
Benadero, Luis   +5 more
core   +3 more sources

Dual‐Active‐Bridge LC Resonant DC–DC Converter With an Auxiliary Boost Arm for Battery Energy Storage Systems

open access: yesIET Electrical Systems in Transportation, Volume 2025, Issue 1, 2025.
This study presents a dual‐active‐bridge (DAB) LC resonant DC–DC converter for battery energy storage systems. The proposed converter adds an auxiliary bridge arm to the traditional full‐bridge (FB) LC resonant converter as a boost arm. It features two efficient operating modes: a charging low‐gain (CLG) mode and a discharging high‐gain (DHG) mode.
Yisheng Yuan, Wei Liu, Jagabar Sathik
wiley   +1 more source

Advanced DC–DC Converter Topologies for Electric Vehicles: Wide Bandgap Technologies, Emerging Trends and Future Challenges

open access: yesElectrical Materials and Applications, Volume 2, Issue 1, January/December 2025.
This review summarises advanced DC–DC converter topologies for BEVs, HEVs, PHEVs and FCEVs, emphasising high‐efficiency wide bandgap (SiC/GaN) devices and bidirectional power flow. It highlights challenges, such as EMI, thermal management and emerging AI‐driven diagnostics, for future electric vehicle power electronics.
Abhilash Sakhare, Suresh Mikkili
wiley   +1 more source

A Novel Three-Phase Six-Switch PFC Rectifier with Zero-Voltage-Switching and Zero-Current-Switching Features

open access: yesEnergies, 2019
A novel three-phase power-factor-correction (PFC) rectifier with zero-voltage-switching (ZVS) in six main switches and zero-current-switching (ZCS) in the auxiliary switch is proposed, analyzed, and experimentally verified.
Chun-Wei Lin   +2 more
doaj   +1 more source

Novel Soft-Switching Integrated Boost DC-DC Converter for PV Power System

open access: yesEnergies, 2020
This paper presents a novel soft-switching boost DC-DC converter, which uses an edge-resonant switch capacitor based on the pulse width modulation PWM technique.
Khairy Sayed   +2 more
doaj   +1 more source

Design and control of isolated current‐fed DC–DC converters for fuel cell stacks EIS incorporating wide‐frequency‐range of perturbations

open access: yesIET Power Electronics, Volume 18, Issue 1, January/December 2025.
A fuel‐cell‐dedicated power conditioning converter capable of presenting a wide‐range frequencies of electrochemical impedance spectroscopy perturbations while not impacting system integration is achieved in this paper. Abstract Electrochemical impedance spectroscopy (EIS) performed by power converters makes in situ diagnostics possible for fuel cell ...
Jiabin Shen, Jiacheng Wang
wiley   +1 more source

A Zero Input Current Ripple ZVS/ZCS Boost Converter with Boundary-Mode Control

open access: yesEnergies, 2014
In this paper, in order to achieve zero ripple conditions, the use of a ripple mirror (RM) circuit for the boost converter is proposed. The operation modes are studied and steady-state analyses performed to show the merits of the proposed converter.
Ching-Ming Lai   +2 more
doaj   +1 more source

Digital control of dual-load LCLC resonant converters [PDF]

open access: yes, 2005
The paper proposes the analysis, design and realisation of dual-output resonant LCLC converters with independent output regulation, employing a single power stage and combined PWM and frequency control.
Ang, Y A   +3 more
core   +1 more source

Home - About - Disclaimer - Privacy