Results 11 to 20 of about 521 (125)
IEEE Access, 2021 This paper presents the concept and results of a novel resonant DC-DC converter which achieves high voltage gain at a low number of utilized switches, low voltage stress on transistors, ZVS and ZCS operation, high efficiency and variable voltage gain ...
Szymon Folmer, Robert Stala
doaj +1 more source
Discontinuous Current Mode Modeling and Zero Current Switching of Flyback Converter
Energies, 2021 The flyback converters are widely used in low power applications. The switch typically requires 600 V breakdown voltage in order to perform large step-down voltage.
Rustam Kumar +5 more
doaj +1 more source
IEEE Open Journal of Power Electronics, 2020 A general PWM method for soft-switching three-phase power converters-Edge Aligned PWM (EA-PWM) is proposed. It aligns all the high loss commutation instants of the converter bridges in a switching cycle at the same instant so that all the switches of the
Keyan Shi, Jinyi Deng, Dehong Xu
doaj +1 more source
Load‐independent inverse class‐E ZVS inverter and its application to wireless power transfer systems
IET Power Electronics, 2022 This paper proposes a load‐independent inverse class‐E zero‐voltage switching (ZVS) inverter. The proposed inverter achieves the constant output current and the ZVS at any load resistance without any control.
Ayano Komanaka +4 more
doaj +1 more source
Extension of Zero Voltage Switching Capability for CLLC Resonant Converter
Energies, 2019 TheCLLC resonant converter has been widely used to obtaina high power conversion efficiency with sinusoidal current waveforms and a soft switching capability. However, it has a limited voltage gain range according to the input voltage variation.
HwaPyeong Park +3 more
doaj +1 more source
PLL controller for achieving zero‐voltage switching (ZVS) in inductorless half‐bridge drive piezoelectric transformer resonant power supplies [PDF]
The Journal of Engineering, 2019 Inductorless half‐bridge, piezoelectric transformer (PT) resonant power supplies require careful control if zero‐voltage switching (ZVS) of the MOSFETs is to be achieved. Here, the authors describe how a phase‐locked loop (PLL) may be used to achieve this by ensuring adequate deadtime exists between the two MOSFETs to allow the PT input voltage to ...
Foster, M.P. +3 more
openaire +3 more sources
Journal of Power Electronics, 2015 In this paper, a revolutionary buck converter is proposed with soft-switching technology, which is realized by a coupled inductor. Both zero-voltage switching (ZVS) of main switch and zero-current switching (ZCS) of freewheeling diode are achieved at turn on and turn off without using any auxiliary circuits by the resonance between the parasitic ...
Xinxin Wei +3 more
openaire +2 more sources
Implementation of Single Phase Soft Switched PFC Converter for Plug-in-Hybrid Electric Vehicles
Energies, 2015 This paper presents a new soft switching boost converter with a passive snubber cell without additional active switches for battery charging systems. The proposed snubber finds its application in the front-end ac-dc converter of Plug-in Hybrid Electric ...
Aiswariya Sekar, Dhanasekaran Raghavan
doaj +1 more source
Journal of Electrical and Computer Engineering, 2023 This study offers a thorough examination of the zero voltage switching (ZVS) operation range and deadband conditions for a bidirectional DC-DC converter with phase shift control, featuring dual H-bridge. The analysis considers the soft switching range of
Ahmed Hamed Ahmed Adam +3 more
doaj +1 more source
Single-Switch Non-Isolated Resonant DC-DC Converter for Single-Input Dual-Output Applications
Applied Sciences, 2023 This paper describes a new configuration of Cuk and SEPIC (Single-Ended Primary Converter) ZVS-QR (zero-voltage switching quasi-resonant) combination DC-DC converter for bipolar output with a single switch.
Cristian Díaz-Martín +4 more
doaj +1 more source