Results 101 to 110 of about 11,980 (262)
Saudi Endodontic JournalAs the use of monolithic zirconia crowns continues to increase in clinical practice, understanding the impact of post-cementation endodontic intervention is essential for long-term restorative success.
Abdulrahman Almalki
doaj +1 more source
The study on wear and aging performance of polyetheretherketone, zirconia, and cobalt-chromium alloy crowns [PDF]
Kouqiang yixueObjective To comparatively analyze the friction wear performance, fracture resistance, and displacement resistance before and after aging of full crowns made from PEEK, cobalt-chromium alloy, and zirconia, providing a theoretical basis for the future ...
YANG Shuo, LI Zhuoheng, ZHANG Huinan, GAO Jingzhe, SUN Yu
doaj +1 more source
Analysis of Flexural Strength and Contact Pressure After Simulated Chairside Adjustment of Pressed Lithium Disilicate Glass-Ceramic [PDF]
, 2018 Statement of problem Research evaluating load-to-failure of pressed lithium disilicate glass-ceramic (LDGC) with a clinically validated test after adjustment and repair procedures is scarce.
Berzins, David W. +3 more
core +1 more source
Mechanical behavior of single-layer ceramized zirconia abutments for dental implant prosthetic rehabilitation [PDF]
, 2014 Objectives: This study was undertaken to characterize the mechanical response of bare (as-received) and single- layer ceramized zirconia abutments with both internal and external connections that have been developed to enhan - ced aesthetic ...
Bruguera Alvarez, August +9 more
core +1 more source
Clinical fractures of veneered zirconia single crowns.
General dentistry, 2016 Crowns made from an yttria-stabilized tetragonal zirconia polycrystals (3Y-TZP) core with a porcelain veneer have shown high clinical failure rates. Manifestations of clinical failure in veneering ceramic ranges from a single chip to an extended fracture. Core failures are uncommon but usually are catastrophic. This article examines the possible causes
De Almeida Jr., Antonio Alves +3 more
openaire +2 more sources
Journal of Esthetic and Restorative Dentistry, EarlyView.ABSTRACT Objective This in vitro study aimed to evaluate the effects of substructure color and restoration thickness on the final color of shade‐gradient ultra‐translucent zirconia ceramics. Material and Methods A total of 180 flat‐shaped ultra‐translucent zirconia specimens (5Y‐PSZ) with thicknesses of 0.4, 0.6, and 0.8 mm (n = 60) were fabricated and
Elif Yılmaz Biçer +2 more
wiley +1 more source
BMC Oral HealthBackground Primary tooth wear is a common phenomenon that affects chewing ability, dental sensitivity, aesthetics, and occlusion. This study was conducted to compare the antagonistic enamel wear of primary molars opposed to four different crown materials.
Diana Mohamed Amer +1 more
doaj +1 more source
Saudi Dental Journal, 2015 Statement of problem: In some clinical conditions minimally invasive complete crown tooth preparations are indicated. This is especially true when gross removal of tooth structure would weaken the remaining tooth or violate the vitality of the dental ...
Fatemeh A. Amir Rad +2 more
doaj +1 more source
A Method of Locating the Abutment Screw Access Channel with Cone-Beam Computed Tomography and a 3D-Printed Drilling Guide [PDF]
, 2018 In managing loose abutment screws, locating precisely the position of the screw access channel is difficult. This technique describes the use of cone-beam computed tomography (CBCT) and surgical guide planning software to locate the screw access channel ...
Asiri, Waleed Nasir +3 more
core +1 more source
Tribo-corrosion of steel in artificial saliva [PDF]
, 2014 Stainless steel is widely used as dental implant. However, there has been little work on the micro-abrasion of such materials in laboratory simulated oral environments, where abrasion, sliding wear can interact simultaneously.
Holmes, D., Sharifi, S., Stack, M. M.
core +1 more source