Results 111 to 120 of about 156,786 (215)
Novel Ultrahigh-Performance ZnO-Based Varistor Ceramics. [PDF]
Tian T +8 more
europepmc +1 more source
Enhancement in the Structural, Electrical, Optical, and Photocatalytic Properties of La2O3-Doped ZnO Nanostructures. [PDF]
Ganesh V +10 more
europepmc +1 more source
Structural and electrical properties of ZnO varistors containing different spinel phases
Structural and electrical properties of ZnO varistors were investigated as a function of spinel composition. Six varistor mixtures differing only in chemical composition of spinel, were prepared by mixing separately synthesized constituent phases (DSCP ...
Brankovic, G. +12 more
core +1 more source
Lightning strikes are a major cause of wind turbine (WT) damage, with approximately 80% of cloud-to-ground lightning strikes exhibiting a multi-stroke characteristic. Therefore, studying the transient overvoltages induced by multiple lightning strokes is
Jie Zhang +7 more
doaj +1 more source
Faults of ZnO Crystal in ZnO Varistor.
Iga, Atsushi +2 more
openaire +2 more sources
Dielectric Loss and Electrical Conductivity Behaviors of Epoxy Composites Containing Semiconducting ZnO Varistor Particles. [PDF]
Lei L, Chen C, Nie H, Wu X, Tan DQ.
europepmc +1 more source
The effect of Cr2O3 on the electrical properties of the multicomponent ZnO varistors was investigated using voltage-current curves and impedance spectroscopy.
Bulhoes, LOS +4 more
core +1 more source
Synergistic Effects of Pr6O11 and Co3O4 on Electrical and Microstructure Features of ZnO-BaTiO3 Varistor Ceramics. [PDF]
Shaifudin MS +9 more
europepmc +1 more source
CO2 and CO Capture on the ZnO Surface: A GCMC and Electronic Structure Study. [PDF]
Gordijo JS, Rodrigues NM, Martins JBL.
europepmc +1 more source
PROCESSING AND CHARACTERIZATION OF LOW-VOLTAGE VARISTORS
ZnO seed particles and Cr2O3 were used in this study to control the microstructure of ZnO varistors. The seed particles were prepared by adding 1.0 mol % BaO to ZnO. The powder was then calcined at 800-degrees-C for 2 h, pressed into pellets and sintered
Longo, Elson +3 more
core

