Results 91 to 100 of about 122,447 (215)

INTRINSIC DEFECTS IN ZnO VARISTOR CERAMICS

open access: yesActa Physica Sinica, 1996
The relationship between dielectric loss factor D (tanδ) and frequency for ZnO-Sb2O3-BaO and ZnO-Bi2O3-Sb2O3-BaO varistor ceramics has been investigated. A new dielectric loss peak was found near by 2MHz at room temperature for the sample in the absence of Bi2O3, the corresponding electron trapping level was about 0.18 eV, it was considered that the ...
null FU GANG   +2 more
openaire   +1 more source

Comparative electrical behavior at low and high current of SnO(2)- and ZnO-based varistors [PDF]

open access: yes, 2008
The complete I-V characteristics of SnO(2)-based varistors, particularly of the Pianaro system SCNCr consisting in 98.9%SnO(2)+1%CoO+0.05%Nb(2)O(5)+0.05%Cr(2)O(3), all in mol%, have been seldom reported in the literature.
LONGO, Elson   +10 more
core   +1 more source

Microstructural and nonohmic properties of ZnO.Pr6O11 CoO polycrystalline system

open access: yesMaterials Research, 2010
The microstructure and electrical properties of varistors composed of (95-x) ZnO + x Pr6O11 + 5 CoO (ZPC), (x = 0.1, 0.5 and 1.0) and sintered at 1300 and 1350 °C, were investigated. According to X-ray diffraction, several phases (ZnO, Pr2O3 and Pr2CoO4)
Miguel Angel Ramírez   +5 more
doaj   +1 more source

The Simulation of Failure Modes on ZnO Varistors

open access: yesIEEJ Transactions on Power and Energy, 2008
There are three main failure modes of ZnO varistors; thermal runaway, puncture and cracking. It is important from the operational point of view for user of ZnO surge arresters to know the fundamental mechanisms of these failure modes. I led many equations on these failures and simulated failure modes.
openaire   +1 more source

Influence of processing parameters on microstructure and electrical properties of ZnO-based varistor ceramics

open access: yesDiscover Electronics
ZnO-based varistors are widely used in electrical equipment for surge protection. This research explores the influence of sintering parameters—such as sintering temperature, ramp rate and soaking time—on microstructure development and V-I characteristics
Muhammad Hassan   +3 more
doaj   +1 more source

Desenvolvimento de varistores à base de SnO2 para aplicação em redes de alta tensão Development of SnO2-based varistors for high voltage application

open access: yesCerâmica, 2006
Varistores à base de SnO2 foram preparados pelo processo convencional de mistura de óxidos. As amostras foram sinterizadas a 1250 °C por 2 h. Os difratogramas obtidos por difração de raios X e as análises por microscopia eletrônica de varredura ...
M. M. Oliveira   +6 more
doaj   +1 more source

Síntese de nanocristais de ZnO via processamento soloquímico [PDF]

open access: yes, 2012
Tese (doutorado) - Universidade Federal de Santa Catarina, Centro Tecnológico, Programa de Pós-Graduação em Engenharia Química, Florianópolis, 2010Este trabalho propõe um método simples, baseado no processamento soloquímico convencional, para produção de
Gusatti, Marivone
core  

Processing parameters for ZnO-based thick film varistors obtained by screen printing

open access: yesBoletín de la Sociedad Española de Cerámica y Vidrio, 2006
Thick film varistors based on the ZnO-Bi2O3-Sb2O3 system have been prepared by screen printing on dense alumina substrates. Different processing parameters like the paste viscosity, burn out and sintering cycles, green and sintered thickness, have been ...
de la Rubia, M. A.   +9 more
doaj  

Full-Lifecycle Deterioration Characteristics and Remaining Life Prediction of ZnO Varistors Based on PSO-SVR and iForest

open access: yesEnergies
To address three core deficiencies of the existing research on ZnO varistors (incomplete full-lifecycle datasets, insufficient characterization robustness due to the lack of multi-parameter complementarity, and disconnected remaining life prediction and ...
Zhiheng Zhu   +4 more
doaj   +1 more source

Home - About - Disclaimer - Privacy