Results 41 to 50 of about 154,259 (285)
Zr-Doped NiO Nanoparticles for Low-Temperature Methane Combustion
, 2021 The development of efficient and stable non-noble metal-based catalysts for low-temperature methane combustion is extremely important and still a profound challenge. Herein, high-performance Ni1–xZrxO2−δ solid solution nanocatalysts were prepared through
Zhixiong Wang +11 more
core +1 more source
Arthritis Care &Research, EarlyView.Objective To evaluate whether extending the American College of Rheumatology–recommended monitoring interval for complete blood count and liver function tests in patients receiving methotrexate (MTX) affects timely detection of medication‐related toxicity.
Spencer Simko +4 more
wiley +1 more source
The effect of Zr addition on the laser welding of SiCp/2A14Al composite
Journal of Materials Research and Technology, 2021 Zr foil was applied in the laser welding of SiCp/2A14Al composites. The Al4C3 phase and pores was decreased in the fusion zone with Zr addition. The area of fusion zone decreased with the amount of Zr addition.
Gaoyang Mi +4 more
doaj +1 more source
Caregiver Perspectives on the Burden of Disease and Treatment in Uncontrolled Gout
Arthritis Care &Research, EarlyView.Objective Uncontrolled gout (UG) refers to persistently elevated serum urate (SU) levels >6 mg/dL and ongoing gout symptoms despite use of urate‐lowering therapy (ULT). The objective of this study was to evaluate the burden associated with informal caregiving for individuals with UG.
Angelo Gaffo +6 more
wiley +1 more source
International Journal of Nanomedicine, 2020 Bilal Javed,1,2 Zia-ur-Rehman Mashwani2 1Roy & Diana Vagelos Laboratories, Department of Chemistry, University of Pennsylvania, Philadelphia, PA 19104-6323, USA; 2Department of Botany, PMAS Arid Agriculture University, Rawalpindi, Punjab 46300 ...
Javed B, Mashwani ZR
doaj
Electrochemical Behavior of Zirconium in an in-situ Preparing LiCl−KCl−ZrCl4 Molten Slat
International Journal of Electrochemical Science, 2015 The electrochemical behavior of zirconium was investigated in an in-situ preparing LiCl−KCl−ZrCl4 molten slat at 773 K by cyclic voltammetry, chronopotentiometry, and open circuit chronopotentiometry.
Yanqing Cai +5 more
doaj +1 more source
Advanced Engineering Materials, Volume 27, Issue 6, March 2025.The stability criteria affecting the formation of high‐entropy alloys, particularly focusing in supersaturated solid solutions produced by mechanical alloying, are analyzed. Criteria based on Hume–Rothery rules are distinguished from those derived from thermodynamic relations. The formers are generally applicable to mechanically alloyed samples.
Javier S. Blázquez +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Reproduction of stacking fault energy calculations from literature with a semi‐automated large language model‐assisted extraction procedure: extraction of simulation protocol, atomistic structures, computational parameters, and reported results, ontology alignment, knowledge graph construction and, finally, recomputation forvalidation.
Sepideh Baghaee Ravari +5 more
wiley +1 more source
Insights into the accessibility of Zr in Zr/SBA-15 mesoporous silica supports with increasing Zr loadings [PDF]
Microporous and Mesoporous Materials, 2016 Oxide-promoted SBA-15 materials have been shown to be profitable in a wide variety of catalytic reactions of environmental interest. Zr-SBA-15 materials have been found to be of particular interest in hydrotreating, biomass conversion and Fisher–Tropsch synthesis.
Ogura, Masaru +7 more
openaire +2 more sources
Advanced Engineering Materials, EarlyView.Experiments and thermophysical simulations were conducted to investigate the electron beam powder bed fusion electron beam (PBF‐EB/M) process for the γ′‐strengthened nickel‐based superalloy Inconel 738LC. The results demonstrate the impact of process‐induced microstructural variations on high‐temperature mechanical behavior, providing a basis for ...
Jan Niklas Petenati +11 more
wiley +1 more source