Results 81 to 90 of about 924,643 (269)
Microstructure Design of Steel‐Spinel Composites via Spark Plasma Sintering Process
Advanced Engineering Materials, EarlyView.This study illustrates how spark plasma sintering at reduced oxygen partial pressure enables controlled formation of steel‐spinel composites through tailored redox reactions and cation exchange. Comparison of the MgO–Fe2O3, steel–(MgO+Cr2O3), and steel–(MgO+Fe2O3) systems shows how oxygen activity and interface chemistry govern spinel formation, phase ...
Mahnaz Mehdizadehlima +4 more
wiley +1 more source
Ground-based adaptive optics coronagraphic performance under closed-loop predictive control
, 2017 The discovery of the exoplanet Proxima b highlights the potential for the coming generation of giant segmented mirror telescopes (GSMTs) to characterize terrestrial --- potentially habitable --- planets orbiting nearby stars with direct imaging.
Guyon, Olivier, Males, Jared R.
core +1 more source
Microstructure Evolution of a VMnFeCoNi High‐Entropy Alloy After Synthesis, Swaging, and Annealing
Advanced Engineering Materials, EarlyView.The synthesis and processing (rotary swaging and annealing) of the novel VMnFeCoNi alloy is investigated, alongside the estimation of the grain size effect on hardness. Analysis of a wide grain size range of recrystallized microstructures (12–210 µm) reveals a low annealing twin density.
Aditya Srinivasan Tirunilai +6 more
wiley +1 more source
Gaoya dianqi, 2021 当±800 kV新东直流正常运行时,±800 kV昆柳龙线路与其部分线段并行,昆柳龙线路感应电压远远高于其他直流线路感应电压。文中利用有限元仿真软件建立新东直流和昆柳龙直流并行线段的二维仿真计算模型,仿真了新东直流输电线路带电运行情况下昆柳龙直流线路的感应电压特性。结果表明:柳北站—龙门站线路在静电场单独作用下,正极感应电压为6 kV,负极感应电压12 k V;在静电场与离子流场的合成电场作用下,正极感应电压为20.7 kV,负极感应电压30.5 kV,这与实际测量结果最高感应电压为42 kV较为接近 ...
杨晓峰 +7 more
doaj
Fatigue Crack Initiation and Growth in Nanocrystalline Ni at Multiple Length‐Scales
Advanced Engineering Materials, EarlyView.Overview of miniaturized in situ SEM fatigue setup and resultant fatigue crack growth data for nanocrystalline Ni. The presented study focuses on the analysis of fatigue crack growth rate (FCGR) in focused ion beam‐notched microcantilevers prepared from nanocrystalline (NC) Ni as a model material.
Igor Moravcik +7 more
wiley +1 more source
Tailoring Functional Properties of Ti–Ni–Cu Shape Memory Alloy Thin Films for MEMS Actuators
Advanced Engineering Materials, EarlyView.A comprehensive study of critical parameters required to develop well‐performing Ti–Ni–Cu thin film shape memory alloy microactuators is provided. Materials science and device integration aspects are integrated by addressing structural and physical relationships using complementary characterization techniques as well as a practical fabrication solution
Elaheh Akbarnejad +6 more
wiley +1 more source
Gaoya dianqi, 2008 ZF27-800型GIS是为满足我国西北750 kV输电工程自主研发的800 kV气体绝缘金属封闭开关设备。笔者介绍了ZF27-800型GIS的研制情况,主要对800kV断路器的开断系统、绝缘系统、传动系统和动力系统的关键技术进行了分析,还对GIS中的母线、进出线套管的设计技术进行了说明。
韩国辉, 谭盛武, 韩书谟
doaj
Seismic evaluation of ±800 kV UHVDC disconnect switch by shake table test
The Journal of Engineering, 2019 Disconnect switches, the widely used electrical substation apparatuses, however, were severely damaged in several earthquakes, causing huge economic losses.
Jiayi Wen, Qiang Xie
doaj +1 more source
Creep Properties and Deformation Mechanism of Additively Manufactured NiAl‐CrMo Composites
Advanced Engineering Materials, EarlyView.Additively manufactured NiAl‐CrMo composites contain numerous interfaces and cell boundaries that control their creep response. At 700°C under high applied stress, creep is dominated by dislocation‐controlled power‐law mechanisms. At 800°C–900°C and lower stresses, creep is primarily diffusion‐controlled along cell boundaries.
Jan Vollhüter +9 more
wiley +1 more source
Gaoya dianqi, 2007 介绍了直流输电工程采用的直流滤波器的类型与构成,分析了±800 kV特高压直流输电工程换流器在直流侧产生的谐波的特点,并与±500 kV高压直流输电工程做了比较。以实际的±800 kV特高压直流输电工程为例,对换流器在直流线路上产生的等效谐波干扰电流进行了计算,对不同直流滤波器设置方案下的滤波效果进行了比较,并以计算结果为依据提出了较为合理的±800 kV特高压直流输电工程直流滤波器设置方案,为最终确定实际工程直流滤波器方案具有一定的参考作用。
张万荣, 任军辉, 王蔚华
doaj