Results 31 to 40 of about 1,517,663 (141)

Doping‐Engineered Modulation of Oxygen Vacancy Formation Energy in Gallium Oxide for High‐Performance Solar‐Blind UV Photodetectors

open access: yesRare Metals, Volume 45, Issue 8, August 2026.
ABSTRACT Solar‐blind ultraviolet (UV) photodetectors (SBPDs) play a critical role in applications including UV communication and fire warning systems. Gallium oxide (Ga2O3) has emerged as a promising material due to its wide bandgap and low cost, but suffers from high dark current and slow response speed caused by oxygen vacancy (VO) defects. This work
Yuhao Lin   +14 more
wiley   +1 more source

Microstructure Tailoring of Laser Powder Bed Fused Nb521 Alloy Toward Strength‐Ductility Synergy

open access: yesRare Metals, Volume 45, Issue 8, August 2026.
ABSTRACT Niobium‐based refractory alloys are promising candidates for high‐temperature aerospace structures, yet their limited ambient‐temperature ductility and poor processability remain major barriers to broader implementation. Here, Nb521 alloy was fabricated by laser powder bed fusion (LPBF), and the effects of processing conditions and subsequent ...
Lele Qin   +7 more
wiley   +1 more source

复杂系统变电站偏磁直流分布特性及影响因素分析

open access: yesGaoya dianqi, 2020
研究直流接地极周边交流系统变压器偏磁直流分布特征及其影响因素能够为治理变压器直流偏磁提供理论依据。首先,基于变电站偏磁直流分布模型,分析了各影响因素的作用机理;其次,利用主成分分析法对影响因素进行处理,在此基础上,提出基于神经网络的变电站偏磁直流估测模型;最后,利用某电网变电站监测直流数据对上述分析方法进行验证,分析了偏磁电流对影响因素的敏感性,结果表明,所建模型的有效性,能够为规划阶段避免或降低中性点偏磁直流提供有用参考。
丁国成   +5 more
doaj  

风电集群接入柔直互联多区域协同调频策略 [PDF]

open access: yes全球能源互联网, 2019
由于柔直电网“隔离”了频率信号,互联多区域协同调频问题亟待研究。现有研究大多利用换流站的下垂控制以及直流电压偏差实现频率信号的传递,但忽略了风电集群接入后由风电功率正常波动引起的直流电压偏差干扰,可能导致风电集群在无需调频时频繁地调整出力。对此,提出了基于直流电压偏差及其特征量的多区域协同调频策略,分别针对电网频率偏移和风电功率波动两种场景提取直流电压偏差特征量,包含电压变化量、电压变化率和滤波后的电压分量幅值3个特征,并基于二者的差异设置换流站启动下垂控制的判据。仿真结果验证了所提方法的有效性。
崔阳   +5 more
doaj   +1 more source

High‐Performance Self‐Powered Ultraviolet Photodetector Based on NiO/La‐Doped SrSnO3/Nb‐Doped SrTiO3 Dual‐Heterojunction

open access: yesRare Metals, Volume 45, Issue 7, July 2026.
ABSTRACT The development of high‐performance photodetectors critically relies on innovative interfacial band engineering, a strategy that enables the synergistic enhancement of photocurrent and drastic suppression of dark current. Herein, a self‐powered ultraviolet (UV) photodetector is demonstrated based on a NiO/La‐doped SrSnO3 (LSSO)/Nb‐doped SrTiO3
Wentian Zhang   +7 more
wiley   +1 more source

乘波体压缩面变化对其气动性能影响分析

open access: yes, 2017
乘波体是一种利用激波包裹特性获得高升阻比的高速飞行器构型.已有研究中,乘波体气动性能的改善主要依赖于给定源流场条件下的前缘型线优化.本文采用数值优化和计算流体力学模拟为主要手段分析了乘波体压缩面变化对其气动性能的影响,以期有效拓展乘波体的设计空间.主要内容如下:首先给出了一种基于表面局部变形的乘波体设计方法.其次结合运用增量修正参数化方法、计算流体力学分析和微分演化算法构造了乘波体压缩面外形气动优化设计流程,以一种椭圆锥形流场生成的乘波体作为基准构型开展了无黏优化 ...
崔凯, 李广利, 徐应洲, 肖尧
core   +2 more sources

电涌保护器中压敏电阻并联的方法和理论分析

open access: yesDianci bileiqi, 2004
为了提高电涌保护器中压敏电阻的耐电流冲击性能,可采用压敏电阻的并联组合。通过对并联组合后的压敏电阻电性能的分析,认为电流偏差是由于限制电压不相等(Ua1≠Ua2)和动态电阻不相等(Rz1≠Rz2)两个因素造成的,且动态电阻越大,电流偏差越小。压敏电阻并联时,可取限制电压Ua相等,而动态电阻Rz相差不超过规定值;也可取动态电阻Rz相等,限制电压Ua相差不超过规定值,使电流偏差在10%范围内。
王茂华, 胡克鳌, 张南法
doaj  

Wafer‐Scale Amorphous g‐C3N4 With Broadly Tunable Dielectric Properties for 2D Electronics

open access: yesRare Metals, Volume 45, Issue 7, July 2026.
ABSTRACT Two‐dimensional (2D) semiconductors are regarded as promising candidates for next‐generation electronics due to their superior electrostatic control; however, their performance is severely constrained by the lack of suitable dielectric materials.
Binyin Gao   +13 more
wiley   +1 more source

ZnO压敏陶瓷势垒高度的测量及其应用

open access: yesDianci bileiqi, 2010
系统分析了势垒高度测量的两种常用方法(I-T特性方法和C-V特性方法)成立的条件,发现直接采用lnj~1/T曲线的基本I-T特性方法适用于流过ZnO压敏陶瓷的电流较小,导电机制为热发射电流的情况,且只能得到等效势垒高度,其最大误差为12%~20%。要使测量误差在10%以内,则外施电压的荷电率不应超过0.4~0.6。改进后的I-T特性方法可测量零偏置电压下的势垒高度准0;C-V特性方法仅适用于偏析层厚度可忽略的情况,否则测量值明显偏大;实际上将两种方法相结合,不但能得到较精确的势垒高度准0 ...
成鹏飞, 王玉平, 于长丰
doaj  

Simultaneous Enhancement of Strength–Ductility and Heat Resistance in Al‐Cu‐Mn Alloys Through Sn‐Mediated Precipitation and Ni/Ca‐Induced Grain‐Boundary Engineering

open access: yesRare Metals, Volume 45, Issue 5, May 2026.
ABSTRACT Giga‐casting, a near‐net‐shape manufacturing process widely used in sectors such as new energy vehicles and aerospace, demands aluminum alloys with high integration, efficiency, and comprehensive performance. However, traditional die‐cast alloys still face two core bottlenecks: the strength–ductility trade‐off and high‐temperature ...
Zhanwei Su   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy