Results 21 to 30 of about 806 (131)
电缆传输线模型具有广泛的应用场景,比如电磁暂态仿真、电缆局部放电诊断等。电缆的传输线参数受到电缆接地金属屏蔽层结构的影响。为了分析这种影响,研究了3种屏蔽结构:①整层接地铜屏蔽;②多股铜导线构成的接地屏蔽;③多股铜导线和铅层构成的双层接地屏蔽结构。首先构建了前两种屏蔽结构电缆的二维模型,有限元仿真获得的传输线参数和实测结果的对比验证了仿真的正确性,在此基础上对比分析了3种屏蔽结构对传输线参数的影响。为了解决二维模型无法表征多股铜导线螺旋结构的问题,针对多股铜导线屏蔽电缆构建了三维模型 ...
李岩, 刘云鹏
doaj
ABSTRACT The development of efficient and stable bifunctional electrocatalysts is a key challenge for the industrialization of hydrogen production by water electrolysis. In this work, Co‐doped NiS/Ni3S2 heterostructured nanowire arrays (Co–NiS/Ni3S2 NA) were successfully constructed by precisely modulating the phase‐selective behavior of nickel ...
Xing‐Hang Liu +2 more
wiley +1 more source
ABSTRACT Emerging as attractive alternatives for sustainable, low‐cost, and high‐performance electromagnetic interference (EMI) shielding, biomass‐derived carbon is nonetheless constrained by a limited repertoire of shielding mechanisms. Herein, a straightforward method was employed to synthesize self‐supporting Co nanoparticles embedded in porous N ...
Yingjie Xu +6 more
wiley +1 more source
笔者针对高压输电线路近区的建筑物空旷处超标工频电场,研究减弱工频电场的方案。以一条220 kV输电线路以及其近区高层建筑物为例,研究架设阳台处屏蔽线的屏蔽效果。文中首先通过实地测量和仿真分析高压输电线路近区的建筑物处电场污染情况。然后构建阳台处屏蔽线的模型,通过仿真软件分析改变屏蔽线的丝径、间隙;屏蔽线与阳台的水平、竖直距离;屏蔽线的封闭完整度对于屏蔽效果的影响。研究表明,在架设阳台处屏蔽线可有效地降低阳台处的工频电场,能够将电场下降到原先的30%以下。同时,采用丝径越大、间隙越小 ...
王凯 +5 more
doaj
ABSTRACT The development of high‐performance electromagnetic protection materials integrating broadband absorption and effective shielding capabilities is hindered by challenges in simultaneously optimizing multiple electromagnetic properties through conventional material designs.
Changlong Du +9 more
wiley +1 more source
为改善架空输电线路下方工频电场分布,在线路下方架设屏蔽线。考虑线路档距、弧垂等因素的影响,建立高压架空输电线路工频电场三维仿真计算模型,研究架设屏蔽线改善高压输电线路下方工频电场的效果,分析讨论了屏蔽线架设高度、横向位置、间距、根数等对线路下方及表面工频电场影响的规律和特征。结果表明:架设屏蔽线能够有效改善导线下方空间工频电场;屏蔽线架设高度、横向位置对屏蔽效果影响明显,存在最佳布置位置;屏蔽线间距对其屏蔽效果有一定影响;屏蔽线根数越多,效果越好,但逐渐趋于平缓;架设屏蔽线会增大分裂导线表面电场强度。
杨滔, 赵克江, 刘渝根, 田金虎
doaj
MXene‐Based Electromagnetic Attenuation Materials in Microwave and Terahertz Bands
ABSTRACT MXenes exhibit considerable potential for developing high‐performance electromagnetic (EM) shielding and absorption materials operating across microwave and terahertz frequencies, due to their tunable surface chemistry and exceptional charge carrier transport properties.
Guozheng Zhang +9 more
wiley +1 more source
ABSTRACT Considering the multiple challenges faced by stealth coatings in complex service environments, the development of multifunctional integrated microwave absorbing materials (MAMs) that combine efficient electromagnetic (EM) attenuation with environmental tolerance has become an urgent need. In this work, coral‐like CoNi@Void@C microparticle (MP)
Jiale Wu +8 more
wiley +1 more source
采用Ansys软件计算分析了采用单屏蔽和双屏蔽结构的两种550kV SF6充气套管的电场分布。分析表明,采用单屏蔽结构的与采用双屏蔽结构的550 kV SF6充气套管,均符合设计要求。经绝缘试验验证,两种结构设计的套管均通过了试验。但双屏蔽结构的SF6充气套管,结构较复杂,性价比不及单屏蔽结构的SF6充气套管。
陈琳, 宫瑞磊
doaj
On the Damage Tolerance of Diffusion Bonded Titanium–Aluminum Phase Biomimetic Composites
ABSTRACT The biomimetic design principles of natural structures involve the strategic integration of stiff and compliant phases to synergistically enhance strength and toughness. Its evolutionary refined natural armor, characterized by a specialized microarchitecture, enables superior damage tolerance.
Shuai Tong +10 more
wiley +1 more source

