Results 31 to 40 of about 395,077 (141)

±500kV换流站直流场金具表面电场数值计算

open access: yesGaoya dianqi, 2016
直流换流站高压设备金具表面电场的准确计算有助于电晕控制以及防电晕设计。针对换流站直流场设备复杂、计算区域大、对特殊金具局部表面电场计算精度要求高的特点,以某±500 kV换流站直流场为研究对象,基于电场数值计算方法,建立3D有限元仿真模型,对整个直流场设备进行电场计算,获得了各部位的电位和电场分布计算结果。通过对全模型计算结果进行分析,对其中需要重点关注的部位采用了子模型进行了更精确的求解,获得了更加准确的电场强度数值。最后基于Peek公式对直流场各金具进行了电晕控制安全裕度的评估 ...
周胜   +6 more
doaj  

Synergistic Grain Refinement and Crystal Plane Reconstruction via Shot‐Peening for Highly Reversible Zn Anodes

open access: yesRare Metals, Volume 45, Issue 10, October 2026.
ABSTRACT Aqueous Zn‐ion batteries (AZIBs) are expected to become one of the most promising candidates for large‐scale energy storage, but are impeded by uncontrollable dendrite growth and parasitic reactions. In this study, we propose a simple mechanical shot‐peening (SP) approach for restructuring commercial Zn foils into highly exposed (002)‐textured
Xu Ma   +7 more
wiley   +1 more source

±500kV换流站直流场电场分析及金具表面电场计算

open access: yesDianci bileiqi, 2014
分析了直流和交流电压下绝缘介质内部电场的分布特性。通过支柱绝缘子的二维轴对称模型对比了是否考虑绝缘支柱内部恒定电场情况下,支柱绝缘子均压环表面的电场分布情况。根据对比结果,选择表面场强较大的情况作为直流场的电场分析方法,以考虑较为极端的情况。以昭通±500 k V换流站为研究对象,根据其直流场的实际模型,建立有限元仿真模型,通过计算得到了直流场内出现较大场强的部位以及对应的场强值。对这些金具的起晕校验结果表明所选直流场在电晕控制方面存在较大裕度。本研究对直流场金具的优化设计提供了一定的指导。
胡蓉
doaj  

Ultrasonic Vibration Assisted Laser Processing: A Hybrid Paradigm for Extreme Surface Enhancement

open access: yesRare Metals, Volume 45, Issue 10, October 2026.
ABSTRACT Traditional laser processing techniques offer many advantages, but they often encounter limitations such as heat‐affected zones, recast layers, residual tensile stresses, and poor surface finish. The integration of ultrasonic vibration (UV) presents a promising hybrid approach to overcome these challenges by introducing beneficial effects like
Aziz Ul Hassan Mohsan   +6 more
wiley   +1 more source

高频下真空灭弧室纵向磁场仿真

open access: yesGaoya dianqi, 2020
真空灭弧室是机械式高压直流断路器的核心部件,为了有利于熄灭电弧,开断直流电流时,通常利用人工过零技术,在直流电流上叠加高频震荡电流,使得开断故障电流过零。由于直流断路器开断电流为高频电流,灭弧室间隙磁场分布对真空断路器的开断有着决定作用,通过建立三维真空灭弧室触头有限元模型,分析计算高频情况下的真空灭弧室的磁场分布情况。结果表明:高频情况下触头间隙磁场大小以及磁场滞后时间受到严重影响,触头间隙纵向磁场大小与平板触头产生效果类似,这对断路器开断效果很不利。
李如春   +5 more
doaj  

Bias‐Gated Functional Switching on Ti3C2/Cu2O/Au@Ag Heterostructure‐Based Photoelectrochemical Platform: OFF–ON Signal Transduction Detection and Efficient Degradation of Ciprofloxacin

open access: yesRare Metals, Volume 45, Issue 10, October 2026.
ABSTRACT A central challenge in high‐performance photoelectrochemical (PEC) systems is mitigating the intrinsic limitations in photogenerated carrier separation and transport, while enabling efficient broad‐spectrum solar harvesting. Inspired by the synergistic effect between plasmonic resonance and heterojunction built‐in electric fields, a ternary ...
Yuhan Zhang   +8 more
wiley   +1 more source

具有后挡板的喷流流场的数值研究

open access: yes, 1995
对发射台底面与后挡板之间的喷流流场进行了数值研究。采用迎风的Petrov-Galerkin有限元方法求解欧拉方程。描述了喷流出口及挡板附近的流场细节 ...
卞荫贵, 赵烈, 王发民, 于欣
core   +2 more sources

Injectable Piezocatalytic Heterojunction Triggers In Situ ROS Release Coupled With Immunogenic Cell Death for Hepatocellular Carcinoma Therapy

open access: yesRare Metals, Volume 45, Issue 10, October 2026.
ABSTRACT The immunosuppressive milieu of hepatocellular carcinoma (HCC) remains a major obstacle to durable antitumor responses. Mechanical‐energy‐driven piezocatalysis provides a noninvasive means of inducing oxidative damage and immunogenic tumor destruction; however, inefficient utilization of piezoinduced charges and insufficient localization of ...
Mingjian Zhang   +7 more
wiley   +1 more source

零区气流场对湍流模型参数C1e敏感度的仿真分析

open access: yesGaoya dianqi, 2016
湍流模型参数的合理设置是气流场仿真中的要素之一。对于电流零区湍流模型的选择及湍流参数的设置,研究者持有不同的观点。文中针对零区气流场对标准k-epsilon湍流模型参数敏感度大小的问题,基于磁流体动力学原理,以252 k V压气式结构燃弧阶段的动态仿真为基础,计算了电流过零阶段湍流模型参数C1e对气流场的影响偏差百分比。通过特定监测点处气压与温度的对比,分析讨论了引起敏感度数值差异较大的原因。研究表明,湍流模型参数C1e的改变对喷口区域内气体压力的影响较小,对于气体温度的影响相对较大 ...
吴杰   +6 more
doaj  

Sulfur Vacancy Modulation‐Induced Electronic Rearrangement in S‐Scheme BaTiO3@ZnIn2S4 Heterojunctions: Toward Synergistic Piezo‐Photocatalytic H2O2 Evolution

open access: yesRare Metals, Volume 45, Issue 10, October 2026.
ABSTRACT High‐yield photocatalytic H2O2 production in sacrificial agent‐free pure water constitutes a critical bottleneck requiring urgent advances in energy catalysis. Although ZnIn2S4 (ZIS) exhibits favourable visible light absorption, it is plagued by severe bulk charge carrier recombination and scarce accessible surface‐active sites.
Sheng Liu   +7 more
wiley   +1 more source

Home - About - Disclaimer - Privacy