Results 91 to 100 of about 9,508 (188)
Gaoya dianqi, 2011 带有弹簧压力系统的电缆附件,如果界面接触应力不足,则易出现放电现象;如果界面接触应力太大则可能导致电缆绝缘缩径。笔者通过电气性能试验确定了220 kV交联电缆干式GIS终端应用硅橡胶应力锥时所需的弹簧压力。通过冷态、热态试验验证了所设计弹簧系统的可靠性。最后应用ANSYS软件计算了在弹簧压力和过盈装配共同作用下的GIS终端界面接触应力。
王海鱼 +5 more
doaj
Micro-CT analysis of high temperature creep damage of 2D C/SiC composites [PDF]
, 2011 利用显微CT针对自愈合2dC/SIC复合材料高温蠕变试验前后的内部孔隙率进行了分。析结果表明,显微CT技术能较好地探测高温蠕变前后2dC/SIC复合材料内部孔隙率变化,从孔隙率的变化初步证实了bXC组元对2dC/SIC复合材料有一定的自愈合作用。利用显微CT技术证实了高温下的拉伸应力不会导致2dC/SIC复合材料中新的裂纹产生。We report a micro-CT experiment that permits us to assess void growth and microstructure ...
冯炎建 +5 more
core
An integrated DIC and CPG investigation of the model-I fracture features for granites after cyclic heating-cooling treatments [PDF]
The thermo-mechanical properties of deep reservoir rocks, especially the damage and failure characteristics under heating-cooling cycles, are of great importance to the stability analysis of well wall and the evaluation of geothermal extraction ...
Gan FENG +5 more
core +1 more source
Shuitu Baochi Xuebao, 2008 应用平衡吸附法,研究了不同pH、离子强度、温度、Cu~(2 )浓度和接触时间条件下,暗棕壤对Cu~(2 )的吸附作用,并利用热力学和动力学方程对实验结果进行了拟合。结果表明:(1)随pH提高,Cu~(2 )的吸附率增加,pH 8时的吸附率约为91%。(2)随体系离子强度增加,Cu~(2 )的吸附量先下降后增加。(3)随溶液中Cu~(2 )浓度增加,Cu~(2 )在暗棕壤上的吸附量也增加,并且在低浓度时增加比较迅速。吸附等温线可用Frendlich,Langmiur和Temkin方程很好的描述 ...
王帅 +4 more
doaj
Dianci bileiqi, 2010 研究避雷器及其比例单元的散热特性是考核避雷器热稳定性的关键。基于引起MOA温升的主要因素,试验研究了在工频电压加热、方波冲击电流及烘箱加热等不同试验条件下MOA及其比例单元的散热特性,并运用工程有限元软件ANSYS建模解析,给出了相应的散热时间常数和降温曲线。试验及解析结果表明:加热方式对MOA的散热特性影响较大,考核比例单元与整只MOA的热等价性时应保证加热方式和加热时间相同;相同外套等结构下,比例单元的轴向散热能力强于整只MOA,为了保证比例单元的散热能力等价于整只MOA,必须采取隔热措施 ...
张搏宇 +5 more
doaj
Geological conditions of coal reservoir occurrence in the Southern Qinshui Basin and its impact on permeability [PDF]
The occurrence and output of coalbed methane (CBM) are controlled by the occurrence geological conditions of coal reservoirs, such as stress, pressure, and temperature.
Huaxin REN +5 more
core +1 more source
Mechanical Properties of Sandstone after High Temperature [PDF]
, 2016 In this study, we conducted a number of mechanical experiments on sandstone samples from Junan County, Linyi City, in order to investigate the mechanical properties of the sandstone samples after being subjected to high temperatures, ranging from 25 ℃ to
Geng, Jishi +3 more
core
Jianzhu Gangjiegou Jinzhan, 2019 整体节点由于存在大量焊缝,在往复荷载作用下,往往会引起疲劳问题。目前,对整体节点疲劳性能的研究仅限于某一特定工程的验证性试验,缺乏系统性的疲劳寿命评估方法的研究。详细介绍了热点应力法、有效缺口应力法和局部应变法的分析过程和适用范围,并结合一种简化焊接试件的疲劳试验,分别采用这几种方法对整体节点的疲劳寿命进行了分析。在此基础上,将分析结果与试验数据、相关规范进行对比,发现热点应力法和有效缺口应力法均能在一定程度上预测疲劳寿命的变化趋势,二者计算结果相似,但对实际工程偏危险 ...
郭琪, 邢颖, 韩庆华, 黄欣
doaj