Results 11 to 20 of about 288,553 (154)
Hybrid Flexible–Soft Neural Interface as a Practical Solution for Long‐Term Implants
Rare Metals, Volume 45, Issue 9, September 2026.ABSTRACT Implantable neural interfaces face persistent challenges in long‐term functionality due to chronic immune responses, mechanical mismatch with tissue, and material corrosion in vivo. The commonly used flexible materials, such as polyimide and parylene‐C (poly[monochloro‐p‐xylylene]), have advantages in low water vapor permeability and high ...
Bowen Ji +13 more
wiley +1 more source
Rare Metals, Volume 45, Issue 8, August 2026.ABSTRACT To meet the escalating demand for high‐performance LiCoO2 (LCO) cathodes, elevating the charging cut‐off voltage becomes highly imperative to achieve markedly enhanced specific capacities. However, high‐voltage operation is always accompanied by structural instability, notably deleterious bulk phase transitions and severe interfacial ...
Jiawei Mu +7 more
wiley +1 more source
随机变幅载荷下海水腐蚀疲劳裂纹扩展速率的断裂力学参量选择 [PDF]
, 1994 ＃ 本文就随机变幅载荷下疲劳裂纹扩展速率的断裂力学参量的选择进行了分析;并与压机变幅载荷下焊接接头海水腐蚀疲劳裂纹扩展试验数据进行了比较;由此认为采用△K_(rms) ;作为断裂学控制参量是可取的;并且认为用常幅循环加载下的焊接接头海水腐蚀疲劳裂纹扩展速率曲线代替以△K_(rms)为参量的随机变幅加载下的裂纹扩展速率曲线;以此来估算其海水腐蚀疲劳裂纹扩展寿命;在工程应用上不仅方便可行 ...
薛以年, 徐纪林
core +2 more sources
Rare Metals, Volume 45, Issue 8, August 2026.ABSTRACT Infrared (IR) stealth is crucial for improving the survivability of equipment. The growing demand for service in marine environments poses new challenges to the composition and structural design of existing IR stealth coatings. This study first investigates the effects of NaCl/water vapor corrosion on the IR stealth performance of GH3536 and a
Kang Wang +5 more
wiley +1 more source
Gongye shui chuli, 2015 实验研究了威灵仙提取液的制备及其对模拟工业循环冷却水中Q235钢的缓蚀性能。紫外吸收光谱、电化学极化曲线、阻抗谱以及腐蚀失重等实验结果表明,综合考虑溶出率与缓蚀率,80℃水溶提取效果好于醇、酸助提;提取液投加量为7.52×10-3 g/mL时对Q235钢的缓蚀率达92.1%、腐蚀速率降至0.043 0 mm/a;缓蚀类型属于阳极型腐蚀抑制。
梁文, 王敏, 张文凯, 周桃玉
doaj +2 more sources
Rare Metals, Volume 45, Issue 7, July 2026.ABSTRACT Mechanical dynamic sealing components are usually subjected to the erosion of a hydrothermal environment; thus, the selected service materials must meet stringent requirements for superior self‐lubrication, corrosion resistance, and thermal stability.
Yanchun Zhao +8 more
wiley +1 more source
Gongye shui chuli, 1990 本文研究采用挂片法与电化学仪器同时测定金属腐蚀率,对所得结果进行了分析比较,发现平均腐蚀速率一时间曲线符合指数函数规律,进而提出了平均腐蚀率渐近值概念。
鲍其鼐
doaj +2 more sources
, 2006 钢基身管镀铬层在高温腐蚀性气体中服役,采用YAG激光器对身管内表面作螺旋线状离散淬火预处理后再电镀铬的复合工艺,形成了基体界面呈激光淬火区/激光未处理区周期性变化的铬层/基体结构.对该身管进行高温腐蚀介质为火药气体的靶场实验.对实验后的基体界面腐蚀形貌与铬层剥落的关系研究表明:次界面裂纹的形成是基体界面高温气体腐蚀的根本原因,基体界面腐蚀的结果是形成基体烧蚀坑,烧蚀坑上的铬层以断裂形式剥落.激光淬火预处理钢基体通过抑制次界面裂纹的形成避免了基体界面高温气体腐蚀损伤 ...
张国祥 +4 more
core +2 more sources
Rare Metals, Volume 45, Issue 7, July 2026.ABSTRACT The mechanical properties and corrosion resistance of traditionally as‐cast soft magnetic Ni‐50Fe alloys often fail to meet current application requirements. To address this limitation, this study employed direct energy deposition (DED) to fabricate two kinds of soft magnetic alloys: Ni‐50Fe and Ni‐48.5Fe‐1.5Cu‐1.5Ti.
Hui Xue +10 more
wiley +1 more source
Rare Metals, Volume 45, Issue 7, July 2026.ABSTRACT Biodegradable Zn‐based alloys are promising candidates for temporary implants, yet excessive Zn2+ release during degradation may induce cytotoxicity and adverse tissue responses. In this study, Zn‐xBa alloys (x = 0.1 wt%, 0.5 wt%, 1.0 wt% and 3.0 wt%) were developed to achieve controlled corrosion behaviors with improved biocompatibility.
Liu‐Dang Fang +9 more
wiley +1 more source