Results 151 to 160 of about 74,346,148 (200)

Effect of Heat Treatment on Microstructure and Mechanical Properties of 17-4PH Stainless Steel Manufactured by Laser-Powder Bed Fusion

open access: yesJournal of Materials Research and Technology, 2023
The 17-4 precipitation-hardened (PH) stainless steel was prepared by laser-powder bed fusion (L-PBF), and the effects of different aging temperatures on the microstructures and properties of 17-4PH stainless steel were systematically studied. The results
Kehong Wang
exaly   +4 more sources

17-4PH Stainless Steel With Excellent Strength–Elongation Combination Developed via Material Extrusion Additive Manufacturing

open access: yesJournal of Materials Research and Technology, 2023
The current study intended to manufacture 17-4PH stainless steel using material extrusion additive manufacturing (MEAM) process and to control the microstructure and mechanical properties of the steel through heat treatment.
So-Yeon Park, Kee-Ahn Lee, Yong-Hoon Cho
exaly   +4 more sources

A Review of the Mechanical Properties of 17-4PH Stainless Steel Produced by Bound Powder Extrusion [PDF]

open access: yesJournal of Manufacturing and Materials Processing, 2023
17-4PH Stainless Steel is a mechanically high-performing alloy that is widely used across chemical and mechanical processing industries. The alloy is conventionally fabricated by cast methods, but emerging additive manufacturing techniques are presently ...
Reza Hashemi, Ana Vafadar
exaly   +4 more sources
Some of the next articles are maybe not open access.

Related searches:

Weldability of 17-4PH Stainless Steel in Overaged Heat Treated Condition

Science and Technology of Welding and Joining, 2006
Studies on the weldability of 17-4PH stainless steel, in the 621°C overaged condition, showed that Creq/Nieq ratio higher than 1·5 resulted in primary ferritic mode of solidification in the weld metal. Post-weld aging treatment at 482°C enhanced the strength of the weld joint with corresponding reduction in impact toughness of the weld metal while ...
C. R. Das   +5 more
exaly   +2 more sources

Heat Treatment Response of Additively Manufactured 17-4PH Stainless Steel

Materials Characterization, 2023
Esmaeil Adabifiroozjaei   +2 more
exaly   +2 more sources

Home - About - Disclaimer - Privacy