Results 91 to 100 of about 74,346,148 (200)

Plasma debinding and sintering of metal injection moulded 17-4PH stainless steel

open access: yesMaterials Research, 2011
In this work, 17-4PH stainless steel parts processed in a Plasma Assisted Debinding and Sintering (PADS) furnace were characterised in terms of microstructure, final density, microhardness, carbon content and tensile behaviour. To determine whether these
Renan Schroeder   +3 more
doaj  

Effect of printing process parameters on tensile strength and wear rate of 17-4PH stainless steel deposited using SLM process

open access: yesFracture and Structural Integrity
In the current work 17-4PH Stainless Steel is deposited using SLM process. It is widely used to build structural parts appropriate for automotive, medical, and aerospace applications. The 17-4 PH SS samples were deposited using technical parameters such
Priya Sahadevan   +4 more
doaj   +1 more source

Six-channel laser single-channel coaxial wire feeding: anisotropy study of component gradient material for 316L and 17-4 PH stainless steel

open access: yesJournal of Materials Research and Technology
A martensitic 17-4 PH stainless steel wire was processed via additive manufacturing using a six-channel laser system. The wire was then replaced mid-process with an austenitic 316 L stainless steel wire to continue printing, ultimately resulting in the ...
Xianwen Yang   +6 more
doaj   +1 more source

Corrosion Behaviour of 304 Austenitic, 15-5PH and 17-4PH Passive Stainless Steels in acid solutions

open access: yesInternational Journal of Electrochemical Science, 2018
The objective of this work was to study is use electrochemical techniques to determinate the growth conditions, characteristics and resistance of passive layers of stainless steel (SS): 304 austenitic, 17-4PH (precipitation hardening) and 15-5PH ...
M. Lara Banda   +8 more
doaj   +1 more source

Laser deposition additive manufacturing of 17-4PH stainless steel on Ti-6Al-4V using V interlayer

open access: yesMaterials Research Letters, 2019
For the first time, additive manufacturing was used to obtain a strong joint (bonding strength >200 MPa) between stainless steel and Ti-6Al-4V using a V interlayer.
Nana Kwabena Adomako   +4 more
doaj   +1 more source

Tribological Performance of CF-PEEK Sliding against 17-4PH Stainless Steel with Various Cermet Coatings for Water Hydraulic Piston Pump Application

open access: yes, 2019
To improve the abrasion resistance performance of the critical tribopairs within water hydraulic piston pumps, tribological characteristics of the stainless steel 17-4PH and 17-4PH coated with Cr3C2-NiCr, WC-10Co-4Cr, Cr2O3 and Al2O3-13%TiO2 sliding ...
Fangli Lou   +3 more
core   +1 more source

Home - About - Disclaimer - Privacy