Results 41 to 50 of about 74,346,148 (200)
Surface finish, microhardness and microstructure of laser metal deposited 17-4PH stainless steel
Laser metal deposition is a metal-based additive manufacturing technology. It is a very sensitive and complex process because of the different process parameters involved and the interrelations between these parameters.
Abiodun Bayode
doaj +1 more source
A significant correlation between scanning strategies and the quality of parts manufactured additively with Selective Laser Melting (SLM) technology is shown.
Sara Giganto +4 more
doaj +1 more source
X‐ray computed tomography reveals how process‐induced defects evolve from green to sintered states in Fused Filament Fabrication (FFF)‐manufactured 17‐4PH stainless steel. Internal porosity, weakest cross‐sections, and fracture locations show strong correlation with tensile performance, demonstrating the potential of computed tomography (CT)‐based ...
György Ledniczky +3 more
wiley +1 more source
Metal fused filament fabrication (FFF) is a promising, multi-step material extrusion process, with debinding and sintering, that offers a low-cost, efficient, and safe alternative for many companies compared to other metal additive manufacturing methods.
M. Naim +3 more
doaj +1 more source
Exploiting Residual Elements Arising from Scrap Steel in Future Sustainable Steel Alloy Design
Herein, the effects of residual elements Cu and Sn on grain growth, recrystallization, and phase transformation in C–Mn steel are summarized, and a case study is presented on how the presence of residual elements can be exploited to reduce deliberate Nb microalloying while achieving the same grain size control and strength during thermomechanical ...
Claire Davis +5 more
wiley +1 more source
The ductile fracture behavior of 17-4PH martensitic stainless steel at high temperature was investigated based on the experimental data of hot uniaxial tensile test.
Chao Feng, Li Zhang, Jian Wu, Hang Yu
doaj +1 more source
Meticulous design and optimization of additive manufacturing (AM) are essential for obtaining high-quality metallic products, particularly using laser powder bed fusion (L-PBF).
Jaehoon Bae +4 more
doaj +1 more source
The valve stem used in the main steam system of nuclear power plant is usually 17-4PH martensitic stainless steel. When it served in 300 C° for a long time, the thermal aging embrittlement of valve stem will be significant, with the performance of the ...
Changyi Zhang +4 more
core +1 more source
ABSTRACT The advent of AM engendered unprecedented control over materials distribution, spurring interest in multi‐material fabrication. Among AM techniques, powder bed fusion—laser beam (PBF‐LB) stands out, although it requires adaptation for multi‐material printing.
Vito Errico +3 more
wiley +1 more source
The impeller under consideration is a rotor wheel of a centrifugal compressor, made of 17-4PH martensitic precipitated hardening stainless steel. Its total operating lifetime was estimated to 80,000 h, but it fractured beforehand, 4 days after the ...
Jakub Łagodziński +2 more
doaj +1 more source

