Results 61 to 70 of about 74,346,148 (200)
Finite element modelling of cold formed stainless steel columns [PDF]
This paper describes the results obtained from a finite element investigation into the load capacity of column members of lipped channel cross-section, cold formed from Type 304 stainless steel, subjected to concentric and eccentric compression loading ...
Rhodes, J., Macdonald, M.
core +5 more sources
Corrosion Behavior of Additively Manufactured Steels: A Comprehensive Review
This review explores the corrosion behavior of various steel types, including austenitic, martensitic, duplex, low‐alloy, and maraging steels, produced via additive manufacturing (AM). It discusses how AM impacts material properties, such as grain structure and the formation of defects like porosity, and highlights the importance of optimizing process ...
Eneko Villabona +4 more
wiley +1 more source
This methodology investigates the determination of the fracture toughness of 3D-printed specimens under monotonic loading conditions. The application is based on the use of a Single Edge Notch Bending (SENB) specimen made by a 3D-printing process (17-4PH
Ali Makke +3 more
doaj +1 more source
ABSTRACT Material extrusion allows for the fabrication of metallic parts with competitive cost and flexibility in setting fabrication parameters. However, the parts contain defects that are due to the deposition route itself and to the removal of polymers during debinding and sintering. These defects affect the mechanical properties.
Eldane Yvana Kamani Tienkoue +3 more
wiley +1 more source
Production of φ350 mm 17-4PH Stainless Steel Practice by EAF-VOD-2.5t ESR-Forging Flow Sheet
The φ350 mm heavy forging products of 17-4PH precipitation hardening stainless steel were produced by EAF-VOD process melting and pig iron mold bottom casting φ320 mm electrode of 17-4PH steel(≤0.04C,16.20~ 16.50Cr,4.50~4.70Ni,3 ...
柯其棠 +3 more
doaj
Water-glycol hydraulic fluid (HFC) has been applied in deep-sea hydraulic systems owing to its flame retardant and environmental performance. However, the corrosion characteristics of metals in HFC have not been widely investigated.
Xu Runzhou +3 more
doaj +1 more source
Graphene-reinforced CrCoNiFeMo high-entropy alloy composite coatings were fabricated on 17-4PH stainless steel by laser cladding for the surface protection of industrial robotic end-effector grippers.
Keqing Wang, Kaiming Xu, Hao Tian
doaj +1 more source
Additively Manufactured 17-4 PH Stainless Steels for Fracture Management Devices. [PDF]
Stainless steel 316L (SS316L) is widely used in fracture management devices. However, SS316L does not offer any bacterial infection resistance and can cause metal-ion sensitivity due to Ni-ions’ presence.
Dash A, Bose S, Bandyopadhyay A.
europepmc +2 more sources
Sintering of 17-4PH stainless steel feedstock for metal injection molding
Abstract The sintering behavior of 17-4PH stainless steel feedstock for metal injection molding was investigated in the temperature range of 650–1050 °C. Effects of sintering conditions, such as sintering temperature and sintering atmosphere, were examined.
Ye, Hezhou +2 more
openaire +3 more sources
A Statistical Review of Hydrogen Effects on the Fatigue and Fracture Behavior of Steel
ABSTRACT This study conducts a statistical re‐analysis of experimental data from the literature to assess the influence of hydrogen on key mechanical properties, including the medium‐/high‐cycle fatigue strength and the threshold value of the stress intensity factor range.
H. Wang +4 more
wiley +1 more source

