Laser surface texturing of a WC-CoNi cemented carbide grade: surface topography design for honing application [PDF]
, 2018 Abrasive effectiveness of composite-like honing stones is related to the intrinsic surface topography resulting from the cubic boron nitride (CBN) grains protruding out of the metallic matrix.
Bähre, Dirk +2 more
core +2 more sources
The Journal of Engineering, 2020 By exploring the effects of energy and velocity under different inlet speeds and abrasive concentrations, different inlet boundary conditions were selected for numerical analysis, and the intrinsic properties of the solid–liquid two-phase abrasive flow ...
Guosong Liu +4 more
doaj +1 more source
Effect of pad and slurry on fixed abrasive polishing of gallium oxide crystal
Jin'gangshi yu moliao moju gongcheng, 2022 Gallium oxide crystal is one of the most representative fourth generation semiconductor materials with the advantages of high band gap, high voltage resistance and short absorption cutoff edge. It has broad application prospects.
Cheng WU +4 more
doaj +1 more source
Effect of abrasive pattern on grinding micro-groove drag-reduction surface
Jin'gangshi yu moliao moju gongcheng, 2022 In order to study the effect of abrasive arrangement pattern on grinding the surface of structured grooves, grinding wheels with three different abrasive orderly arrangements, namely phyllotactic pattern, staggered pattern and array pattern, were used to
Junbo WANG +3 more
doaj +1 more source
Effects of Abrasive Media on Surface Roughness in Barrel Finishing Process [PDF]
International Journal of Advanced Design and Manufacturing Technology, 2020 Barrel finishing is a common technique for surface finishing of industrial parts. Many factors such as working time, abrasive media, initial roughness and machining parameters of rotary barrel affect the final surface roughness of workpieces.
Ali Vakili Sohrforozani +4 more
doaj +1 more source
Ranking of vitrified grinding wheel parameters by using analytical hierarchical process (AHP) for surface roughness of work piece in grinding operation [PDF]
, 2017 Objective of grinding process is to generate high quality surface finish on work piece. There are many parameters which influence on the work piece roughness.
Bhalerao, Y.J., Patil, S.S.
core +1 more source
Study on improving hole quality of 7075 aluminum alloy based on magnetic abrasive finishing
Advances in Mechanical Engineering, 2020 Based on the mechanism of magnetic abrasive finishing, the 7075 aluminum alloy (Al7075) was used in the experimental study. In order to improve wall surface quality and to remove the edge burrs of the hole, a novel magnetic abrasive finishing process was
Anyuan Jiao +3 more
doaj +1 more source
Heat exchanger method, ingot casting; fixed abrasive method, multi-wire slicing, phase 2. Silicon sheet growth development for the large area sheet task of the low cost silicon solar array project [PDF]
, 1978 A crack-free silicon ingot has been cast in a graded, semiconductor purity silica crucible. More than 90% single crystallinity has been achieved in 2.5 kg cast ingots.
Khattak, C. P., Schmid, F.
core +2 more sources
Abrasive water jet drilling of advanced sustainable bio-fibre-reinforced polymer/hybrid composites : a comprehensive analysis of machining-induced damage responses [PDF]
, 2018 This paper aims at investigating the effects of variable traverse speeds on machining-induced damage of fibre-reinforced composites, using the abrasive water jet (AWJ) drilling.
A Alberdi +44 more
core +3 more sources
Particle motion and stain removal during simulated abrasive tooth cleaning [PDF]
, 2007 Stain removal from teeth is important both to prevent decay and for appearance. This is usually achieved using a filament-based toothbrush with a toothpaste consisting of abrasive particles in a carrier fluid.
Addy +22 more
core +2 more sources