Results 1 to 10 of about 2,308 (275)
IET Power Electronics, 2023 This study presents a submodule capacitor voltage self‐balancing method for modular multilevel converters (MMCs) based on switching state matrix construction, which has an advantage over eliminating massive sensor demanding and alleviating computational ...
Zhou Yiyuan +7 more
doaj +1 more source
A new modulation strategy on isolated battery charger with wide input and output voltage range
IET Power Electronics, 2023 A new wide voltage operation range isolated battery charger, which is composed of an asymmetric T‐type AC–DC power rectifier and a modified re‐configurable half bridge DC–DC power converter, is proposed in this paper.
Hurng‐Liahng Jou +5 more
doaj +1 more source
Topology review of doubly grounded transformer‐less single‐phase inverters
IET Power Electronics, 2023 Photovoltaic (PV) transformer‐less single‐phase inverters are widely used in the solar generation systems because of low cost, high power density, and high efficiency.
Zhilei Yao
doaj +1 more source
IET Power Electronics, 2023 In islanded microgrids, when a short circuit or a sudden overload occurs, it provokes an abrupt increment in the currents supplied by the generation nodes, which feed the load collaboratively.
Jaume Miret +4 more
doaj +1 more source
IET Power Electronics, 2023 With the improvement of the penetration of power electronic equipment, a challenging scenario is arising in power‐frequency control system design of virtual synchronous generator (VSG).
Jiaoxin Jia, Xiangwu Yan, Benshuang Qin
doaj +1 more source
IET Power Electronics, 2023 For transformerless current‐fed medium voltage drives, low‐order harmonics of common‐mode voltages (CMVs) are more concerned with than peak values. To mitigate low‐order harmonics, the average values of CMVs should be suppressed.
Hang Gao
doaj +1 more source
IET Generation, Transmission & Distribution, 2023 A switched‐capacitor‐based 13‐level inverter with a lesser number of components is presented in this article. The 13‐level single‐phase AC output voltage is achieved with a voltage gain of 6 by including a single DC source, 11 switches, 4 capacitors, and
Md Reyaz Hussan +5 more
doaj +1 more source
Design and DC fault clearance of modified hybrid MMC with low proportion of full‐bridge submodules
IET Generation, Transmission & Distribution, 2021 The hybrid modular multilevel converter (MMC) consisting of half bridge submodules (HBSMs) and full bridge submodules (FBSMs) combines the respective advantages of both submodules.
Yuzhe Xu, Zheren Zhang, Zheng Xu
doaj +1 more source
A novel axial air‐gap transverse flux switching PM generator: Design, simulation and prototyping
IET Electric Power Applications, 2023 Wind energy as the cleanest source of renewable energy requires a highly efficient lightweight generator that provides maximum power density while having the least vibration noise and maintenance.
Aghil Ghaheri +2 more
doaj +1 more source
IET Power Electronics, 2021 This paper examines a new topology of the AC‐AC Z‐source converter based on asymmetric Gama structure is proposed. The proposed converter has all the common features such as common ground between input and output, realizing the continuous input current ...
Seyyed Mohammad Javad Mousavi +3 more
doaj +1 more source