Results 171 to 180 of about 5,381,996 (392)

A Review of Wet Chemical Etching of Glasses in Hydrofluoric Acid based Solution for Thin Film Silicon Solar Cell Application [PDF]

open access: green, 2017
Hyeongsik Park   +5 more
openalex   +1 more source

Dual‐Interface Engineering of the Source Electrode to Overcome the Intrinsic Injection‐Leakage Trade‐Off in Organic Schottky Barrier Transistors

open access: yesAdvanced Functional Materials, EarlyView.
A charge injection layer is introduced via RIE to decouple the dual functions of the source electrode: lowering contact resistance through doping to enhance charge injection, while SAM modification on the top surface minimizes leakage current. This strategy enables OSBTs to achieve a high on/off ratio with improved stability and performance.
Hye Ryun Sim   +6 more
wiley   +1 more source

Influence of Temperature and Acid Etching Time on the Superficial Characteristics of Ti [PDF]

open access: diamond, 2015
Bruno Ramos Chrcanovic   +2 more
openalex   +1 more source

Electron–Matter Interactions During Electron Beam Nanopatterning

open access: yesAdvanced Functional Materials, EarlyView.
This article reviews the electron–matter interactions important to nanopatterning with electron beam lithography (EBL). Electron–matter interactions, including secondary electron generation routes, polymer radiolysis, and electron beam induced charging, are discussed.
Camila Faccini de Lima   +2 more
wiley   +1 more source

Quantitative evaluation of acid flow behavior in fractures and optimization of design parameters based on acid wormhole filtration losses

open access: yesScientific Reports
The technique of matrix acidification or acid fracturing is commonly utilized to establish communication with natural fractures during reservoir reconstruction.
Sen Yang   +7 more
doaj   +1 more source

Efficient NiOx Hole Transport Layers Enabled by Multifunctional MXenes for High‐Performance Tin‐Lead Perovskite Solar Cells

open access: yesAdvanced Functional Materials, EarlyView.
An efficient NiOx HTL is successfully prepared by introducing MXene as an additive without further surface modification to fabricate high‐performance FASn0.5Pb0.5I3 perovskite solar cells. The introduction of MXene contributes to improved conductivity of NiOx, better aligned at NiOx/perovskite interfaces, and enhanced quality of perovskite films ...
Lijun Chen   +12 more
wiley   +1 more source

From In‐Silico Optimized Microfabrication to Experimental Validation: Engineering a Tridimensional Epi‐Intraneural Interface

open access: yesAdvanced Functional Materials, EarlyView.
An epi‐intraneural interface is developed through in silico optimization and a novel tridimensional microfabrication pipeline. The device integrates penetrating and epineural contacts on a flexible substrate. Mechanical, electrochemical, and in vivo testing in rat and pig reveal robust implantation, low‐threshold activation, and site‐dependent ...
Federico Ciotti   +14 more
wiley   +1 more source

Effect of fiber post space irrigation with different peracetic acid formulations on the bond strength and penetration into the dentinal tubules of self-etching resin cement

open access: green, 2019
Lauriê Garcia Belizário   +5 more
openalex   +1 more source

Home - About - Disclaimer - Privacy