Results 11 to 20 of about 20,095 (267)

A Coordinated Dual-Channel Wide Area Damping Control Strategy for a Doubly-Fed Induction Generator Used for Suppressing Inter-Area Oscillation

open access: yesApplied Sciences, 2019
Using a doubly-fed induction generator (DFIG), with an additional active or reactive damping controller, is a new method of suppressing the inter-area oscillation of a power system. However, using active power modulation (APM) may decrease the damping of
Guowei Cai   +5 more
doaj   +1 more source

A Unified Active Damping for Grid and Converter Current Feedback in Active Front End Converters

open access: yesIEEE Access, 2022
The Active Front End (AFE) is interconnected to the grid with an LCL filter to reduce the switching harmonics. Possible resonances induced by the LCL filter can be damped using Active Damping (AD). In AFE applications, the current sensor can be placed on
Edi Matijevic   +3 more
doaj   +1 more source

Robust Active Damping Control for LCL-Type Shunt Active Power Filters

open access: yesIEEE Access, 2022
A dual-loop current control is discussed for LCL-type shunt active power filters (APFs), where inverter-side current feedback and point of common coupling (PCC) voltage feedforward both provide active damping (AD) effects for LCL resonance.
Lei Yang   +7 more
doaj   +1 more source

Virtual Synchronous Generator (VSG) Control Strategy Based on Improved Damping and Angular Frequency Deviation Feedforward

open access: yesEnergies, 2023
The output active power of a grid-connected inverter controlled by a traditional virtual synchronous generator (VSG) has the problems of oscillation and steady-state errors. A VSG control strategy based on improved damping and angular frequency deviation
Sue Wang, Yuxin Xie
doaj   +1 more source

Active stabilization methods of electric power systems with constant power loads: a review

open access: yesJournal of Modern Power Systems and Clean Energy, 2014
Modern electric power systems have increased the usage of switching power converters. These tightly regulated switching power converters behave as constant power loads (CPLs). They exhibit a negative incremental impedance in small signal analysis.
Mingfei Wu, Dylan Dah-Chuan Lu
doaj   +1 more source

A novel active damping control based on grid-side current feedback for LCL-filter active power filter

open access: yesEnergy Reports, 2020
LCL filter is widely used in grid-connected converters for good harmonic mitigation performance. However, resonance poles of LCL filter challenge system stability, especially in a digital control system.
Tingting Gao   +3 more
doaj   +1 more source

Dynamic Modeling and Vibration Suppression of a Rotating Flexible Beam with Segmented Active Constrained Layer Damping Treatment

open access: yesAerospace, 2023
This paper uses high-order approximate coupling (HOAC) dynamics equations for the hub–beam system with segmented active constrained layer damping treatment (SACLD).
Yue Wang   +5 more
doaj   +1 more source

Energy Efficient Active Vibration Damping [PDF]

open access: yesLinköping Electronic Conference Proceedings, 2013
Mining machines are subjected to severe vibrations during their operation. If we succeed to damp some of those vibrations then we have succeed to reduce the dynamic load of the machine and to improve operator comfort and productivity. The main idea for the research done in this paper is to investigate possible improvements in active vibration damping ...
Emil Zaev, Gerhard Rath, Hubert Kargl
openaire   +1 more source

Review of Magnetorheological Damping Systems on a Seismic Building

open access: yesApplied Sciences, 2021
Building structures are vulnerable to the shocks caused by earthquakes. Buildings that have been destroyed by an earthquake are very detrimental in terms of material loss and mental trauma.
Bhre Wangsa Lenggana   +5 more
doaj   +1 more source

Control of the Weakly Damped System with the Embedded System Support

open access: yesAdvances in Electrical and Electronic Engineering, 2018
This paper deals with the experimental verification of the importance of embedded systems with an applied MEMS sensor in controlling weakly damped systems. The aim is to suppress actively residual oscillations.
Marek Paskala   +2 more
doaj   +1 more source

Home - About - Disclaimer - Privacy