Results 251 to 260 of about 845,516 (306)
Some of the next articles are maybe not open access.
Simulation and comparison between hybrid active power filter and shunt active power filter
2015 International Conference on Electrical, Electronics, Signals, Communication and Optimization (EESCO), 2015The shunt active power filters (SAPFs) and hybrid active power filter (HAPF) is used for practical solution to solve the electric power quality, (EPQ) issues. The emerging power-electronic devices and the new developments in digital signal processing (DSP), have made possible its practical use. The active power filters can compensate the nonlinear load
D.R. Dobariya, P.A. Upadhyay
openaire +1 more source
2016
In this chapter, the active power filters are discussed. In Sect. 3.1, the development of active power filters are reviewed; active power filters with different circuit configurations are given and compared. The three-phase four-wire active power filter using a two level four-leg voltage source inverter (VSI) is discussed in Sect. 3.2. Three-phase four-
Man-Chung Wong +2 more
openaire +1 more source
In this chapter, the active power filters are discussed. In Sect. 3.1, the development of active power filters are reviewed; active power filters with different circuit configurations are given and compared. The three-phase four-wire active power filter using a two level four-leg voltage source inverter (VSI) is discussed in Sect. 3.2. Three-phase four-
Man-Chung Wong +2 more
openaire +1 more source
2013
Shunt active power filters have been introduced as a way to overcome the power quality problems caused by nonlinear and reactive loads [9, 14, 23]. These power electronics devices are designed with the goal of obtaining a power factor close to 1 and achieving current harmonics and reactive power compensation [5, 6, 15]. The usual approaches [5, 15] for
Germán A. Ramos +2 more
openaire +1 more source
Shunt active power filters have been introduced as a way to overcome the power quality problems caused by nonlinear and reactive loads [9, 14, 23]. These power electronics devices are designed with the goal of obtaining a power factor close to 1 and achieving current harmonics and reactive power compensation [5, 6, 15]. The usual approaches [5, 15] for
Germán A. Ramos +2 more
openaire +1 more source
An active power bandpass filter
1978 IEEE Power Electronics Specialists Conference, 1978This paper describes a new approach to the realization of an active 60 hz bandpass power filter. The system uses power switching to minimize attenuation losses and negative feedback to obtain narrowband filtering with a high degree of attenuation, without using large inductors and capacitors.
H. A. Nienhaus +2 more
openaire +1 more source
2016
In this chapter, the hybrid active power filters are discussed. In Sect. 4.1, the development of hybrid active power filters (HAPFs) is initially presented. Then different hybrid active filter (HAPF) topologies have been compared and discussed in details in Sect. 4.2.
Man-Chung Wong +2 more
openaire +1 more source
In this chapter, the hybrid active power filters are discussed. In Sect. 4.1, the development of hybrid active power filters (HAPFs) is initially presented. Then different hybrid active filter (HAPF) topologies have been compared and discussed in details in Sect. 4.2.
Man-Chung Wong +2 more
openaire +1 more source
Active power filters: A review
IEE Proceedings - Electric Power Applications, 2000There has been considerable interest in the development and applications of active filters because of the increasing concern over power quality, at both distribution and consumer levels, and the need to control reactive power and voltage stability at transmission levels.
M. El-Habrouk, M.K. Darwish, P. Mehta
openaire +1 more source
Synchronized active power filter
IEEE Compatibility in Power Electronics, 2005., 2005The aim of the paper is to demonstrate how to use a shunt active power filter to maintain invariable power of a supplying voltage source, even though the supplied load varies randomly. The Section 4.3 is specially related to this feature. The S. Fryze's definition of load current components is used as a basis for the construction of a family of active ...
openaire +1 more source
Heterogeneous active power filter controller
2017 International Symposium ELMAR, 2017The paper describes the architecture of a shunt Active Power Filter (APF) controller composed of three components with different characteristics. Heterogeneous components correspond to the variety of tasks expected from the APF controller. Some of the tasks require real-time execution, some of the requirements are specific to the features of general ...
Andrzej Firlit +2 more
openaire +1 more source
An alternative active power filter
Proceedings of International Conference on Power Electronics, Drives and Energy Systems for Industrial Growth, 2002In this paper, an active power filter module is described. The filter module is used for conditioning line current of a six-pulse static power converter. The proposed module performs two simultaneous duties: it minimizes the supply line current harmonics, generated by the power converter, and compensates the reactive fundamental component of the line ...
M. Taleb +3 more
openaire +1 more source
Single phase active power filter
Proceedings of the 12th IEEE Mediterranean Electrotechnical Conference (IEEE Cat. No.04CH37521), 2004Single phase active power filter (APF) with sliding mode control is analyzed mathematically and by simulation. An APF is power electronics device that is connected parallel to the grid and the load, with task to cancel the reactive and harmonic currents caused by nonlinear loads connected to the grid. Proposed solution is implemented on laboratory test
S. Sladic, M. Odavic, Z. Jakopovic
openaire +1 more source