Modeling Adhesive Wear in Asperity and Rough Surface Contacts: A Review [PDF]
Materials, 2022 I Etsion, Etsion Izhak
exaly +2 more sources
Effects of plasma surface Ta alloying on the tribology behavior of γ-TiAl [PDF]
Journal of Mining and Metallurgy. Section B: Metallurgy, 2021 To improve the wear resistance of γ-TiAl alloy, Ta alloy layer was prepared on surface by double glow plasma surface alloying technique. The tribology behavior of Ta alloy layer against Si3N4 at 25℃, 350℃ and 500℃ were comparatively studied.
Wei D.-B. +5 more
doaj +1 more source
Measurement of Adhesive Wear Share in Laboratory Conditions [PDF]
Transactions of the VŠB-Technical University of Ostrava, Mechanical Series, 2011 The study is focused on the one of possibilities of adhesive wear measurement in laboratory conditions. Adhesive wear share is defined on the basis of tribological quantity such as frictional force, radial wear and frictional temperature.
Martin KOTUS, Zuzana ANDRÁSSYOVÁ
doaj +1 more source
Evaluation of Adhesive Wear Mechanism for Application in Hybrid Tool Wear Model in Hot Forging Process [PDF]
Archives of Metallurgy and Materials, 2019 In hot forging process, tool life is an important factor which influences the economy of production. Wear mechanisms in these processes are dependent on each other, so modeling of them is a difficult problem.
M. Wilkus +3 more
doaj +1 more source
Design and development of a novel sliding friction and wear tester with complex working conditions
Scientific Reports, 2021 Serious wear phenomena occur in mining machinery under complex working conditions, and the wear of machine parts is primarily caused by the synergistic effect of adhesive wear, abrasive wear, corrosive wear, etc.
Jinrong Chai +4 more
doaj +1 more source
Friction and Wear Behavior of NM500 Wear-Resistant Steel in Different Environmental Media
Crystals, 2023 The study aims to investigate the influence of environmental media on the friction and wear behavior of low-alloy wear-resistant steels and to provide practical references for their application.
Guobo Wang +5 more
doaj +1 more source
Influence of Different Displacement Amplitudes on High Temperature Fretting Wear Properties of Cobalt-Based Coatings [PDF]
Cailiao Baohu, 2022 In order to compare the effects of different displacement amplitudes on the fretting wear properties of cobalt-based coatings at high temperature， the CoMoCrSi coating was prepared by the oxygen-assisted supersonic flame spraying process.
CAO Xiaoying, ZHANG Qiang
doaj +1 more source
Microstructure and Wear Behavior of In Situ ZA27/TiB2 Composites
Metals, 2020 In situ ZA27/TiB2 composites were synthesized successfully by diluting the in situ Al/TiB2 composite, which was used as a master alloy. The microstructure and hardness of the developed in situ composites have been investigated.
Fei Chen, Binbin Wang, Zhiqiang Cao
doaj +1 more source
High-temperature friction of 7075 aluminum alloy sheet during hot stamping
工程科学学报, 2020 Aluminum alloys are lightweight materials widely used in the automobile industry because of their high specific strength. As the aluminum alloy with the highest strength at room temperature, 7075 aluminum alloy has great potential for usage in the ...
Jia-song WU +3 more
doaj +1 more source
Journal of Materials Research and Technology, 2021 Revealing the microstructure evolution of materials during the sliding process is crucial to their long-term application. In this study, the friction and wear behaviors of Inconel 718 under different conditions were systematically investigated.
Zhibiao Xu +6 more
doaj +1 more source