Results 181 to 190 of about 68,481 (311)
PPO-Based Reinforcement Learning Control of a Flapping-Wing Robot with a Bio-Inspired Sensing and Actuation Feather Unit. [PDF]
Hussain S, Messaoudi M, Imran M, Tang D.
europepmc +1 more source
EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk +7 more
wiley +1 more source
Dung beetle optimization for probabilistic force analysis of heliostat support structures. [PDF]
Luo H, Liang Y, Xiong Q, Zhang X.
europepmc +1 more source
The subject of this work is the development of a corrosion‐protective coating on steel sheets for form hardening. Rapid heating in an extreme high vacuum (XHV)‐adequate atmosphere is a useful method to prevent oxidation during alloying of 22MnB5 and aluminum to obtain a metallurgical bonding.
Lorenz Albracht +5 more
wiley +1 more source
Collagen hydrolysate is evaluated as a sustainable binder for MgO‐C refractories. Its thermally induced cross‐linking and gas release lead to expansion and cracking in large bricks, but tailored batches with lignin, recyclates, or fine graphite improve the gas release while thermal treatment and stability.
Till M. J. Stadtmüller +8 more
wiley +1 more source
Butterfly Clap-Fling Flight Mechanisms Observed by Schlieren Imaging for the Design of Bio-Inspired Micro Air Vehicles. [PDF]
Prisăcariu EG +5 more
europepmc +1 more source
This paper presents a novel approach to reducing oxide layers on metal powders using low‐temperature hydrogen dielectric barrier discharge plasmas at atmospheric pressure. Unlike conventional hydrogen‐plasma reductions, the powders do not contact the plasma directly.
Shukang Zhang +3 more
wiley +1 more source
Adaptive Bayesian learning for stability characterization of re-entry vehicles. [PDF]
Tiwari B +5 more
europepmc +1 more source
Cermets (60 vol.% AISI 316L stainless steel, 40 vol.% recycled MgO), intended for use in aluminum electrolysis, were pre‐oxidized in three furnaces with different heating technologies and subjected to a cryolite corrosion test. The different atmospheres influenced the formation of oxide layers, which in turn affected corrosion resistance and ...
Patricia Kaiser +4 more
wiley +1 more source
Research on the aerodynamic characteristics of eVTOL aircraft ducted rotor tip embedded inside the ducted body. [PDF]
Du S, Zha Y, Li C, Lu Z, Zhao Q.
europepmc +1 more source

