Results 71 to 80 of about 8,337,340 (284)

ANALISIS PERUBAHAN TEMPERATUR UDARA 2004-2010 UNTUK MEMPREDIKSI TEMPERATUR UDARA 2011-2014 DI KALIMANTAN SELATAN

open access: yesJurnal Fisika Flux, 2017
Abstrak: Nowadays, green house gas was increased which caused air temperature of surface arise, one of them is carbon dioxide (CO2), CO2 is part of green house gas which is strong enough to absorb infrared wave, but if CO2 concentration is too high it ...
Reko Ary Rampan   +2 more
doaj   +3 more sources

Numerical Simulation on the Influence of Air Supply Parameters on Temperature Field in the Core Freezer

open access: yesZhileng xuebao, 2022
To optimize the uniformity of the temperature field distribution inside the core freezer and control the temperature fluctuation range, a test rig of core model and a three-dimensional RNG k-ε turbulence model were built based on the similarity principle
Liu Zeqin, Yu Yongjie, Li Jie
doaj  

Psychological disorders in flying personnel of the Royal Air Force : investigated during the war 1939-45.

open access: yes, 1947
Includes index.; "Issued for the information and guidance of the senior executive and all medical officers of the Royal Air Force".; Electronic reproduction. Canberra, A.C.T.
Great Britain. Air Ministry
core  

A Simplified Laminar Flow Model for the Pultrusion of Glass Fiber/Polyethylene Terephthalate Commingled Yarns

open access: yesAdvanced Engineering Materials, EarlyView.
A simplified thermoplastic pultrusion model is developed to predict thermal fields in glass fiber/polyethylene terephthalate (GF/PET) composites with reduced computational cost. By combining effective material homogenization, validation against literature data, and Gaussian‐process‐based optimization, the study reveals how heating limits, pulling speed,
Elder Soares   +3 more
wiley   +1 more source

Performance Optimization of Air Cooler Using Peltier and SEPIC Converter as Temperature Control

open access: yesEmitor: Jurnal Teknik Elektro
Air cooler has an evaporative mode that is used to get a cooler temperature output than without using evaporative mode. The evaporative cooling process involves water that is cooled with an ice cube placed in a water tank on the air cooler, where the ...
Muchammad Ruben Imawan   +2 more
doaj   +1 more source

New Correlations for the Air-Side Heat Transfer Coefficient of Microchannel Heat Exchangers Under Quasi-Steady State Frosting Operating Conditions [PDF]

open access: yes, 2012
This study experimentally investigated the frost growth on louvered folded fins in outdoor microchannel heat exchangers used in air-source heat pump systems.
Cremaschi, Lorenzo   +2 more
core  

Electrochemical Behavior of Flame‐Sprayed Sc‐Doped AlCoCrFeMo High‐Entropy Alloy Coatings in 3.5% Sodium Chloride Solution

open access: yesAdvanced Engineering Materials, EarlyView.
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar   +7 more
wiley   +1 more source

Numerical simulation of a hot-air cleaning fan for the combine harvester.

open access: yesPLoS ONE
This study aimed to improve the separation efficiency of damp crops by developing a hot-air cleaning fan. First, the aerodynamic performance of two fans with different inlet structures was compared.
Tao Zhang, Guoliang You, Yaoming Li
doaj   +1 more source

Air temperature

open access: yes, 2013
Legacy description not ...
J. Overland   +7 more
openaire   +1 more source

Influence of Scan Strategies in Electron Beam Powder Bed Fusion on Solidification, Microstructure, and High‐Temperature Compressive Properties of γ′‐Strengthened Inconel 738LC

open access: yesAdvanced Engineering Materials, EarlyView.
Experiments and thermophysical simulations were conducted to investigate the electron beam powder bed fusion electron beam (PBF‐EB/M) process for the γ′‐strengthened nickel‐based superalloy Inconel 738LC. The results demonstrate the impact of process‐induced microstructural variations on high‐temperature mechanical behavior, providing a basis for ...
Jan Niklas Petenati   +11 more
wiley   +1 more source

Home - About - Disclaimer - Privacy